Re: [Xen-devel] [PATCH] xen: arm: platforms: Remove determining reset specific values from dts for XGENE.

[George Dunlap <george.dunlap@xxxxxxxxxxxxx>]

On 02/04/2014 09:43 AM, Ian Campbell wrote:
> On Tue, 2014-02-04 at 11:35 +0530, Pranavkumar Sawargaonkar wrote:
> > This patch removes reading reset specific values (address, size and mask) from 
> > dts
> > and uses values defined in the code now.
> > This is because currently xgene reset driver (submitted in linux) is going 
> > through
> > a change (which is not yet accepted), this new driver has a new type of dts 
> > bindings
> > for reset.
> > Hence till linux driver comes to some conclusion, we will use hardcoded values 
> > instead
> > of reading from dts so that xen code will not break due to the linux transition.
> >
> > Ref:
> > http://lists.xen.org/archives/html/xen-devel/2014-01/msg02256.html
> > http://www.gossamer-threads.com/lists/linux/kernel/1845585
> >
> > Signed-off-by: Pranavkumar Sawargaonkar <pranavkumar@xxxxxxxxxx>
> > Signed-off-by: Anup Patel <anup.patel@xxxxxxxxxx>
> Acked-by: Ian Campbell <ian.campbell@xxxxxxxxxx>
>
> George -- I'd like to take this into 4.4 to avoid shipping a Xen which
> relies on an unagreed DTS binding (which is an ABI of sorts).
Is this the reboot binging one with 3 options, #2 of which was hard-code 
the values rather than using DT?
Assuming so:

Release-acked-by: George Dunlap <george.dunlap@xxxxxxxxxxxxx>


_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel