[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Xen-devel] HVM hangs system on AMD A10-6800K + Hudson-D4

>>> On 20.08.13 at 03:42, Darren Shepherd <darren.s.shepherd@xxxxxxxxx> wrote:
> Okay, so I compiled, ran and tested everything between RELEASE-4.3.0 (bad) 
> with master (good).   Unfortunately I came to the conclusion it's not a patch 
> but instead it's the debug flag.  So if I build RELEASE-4.3.0 it fails my 
> test 
> case because because Config.mk has "debug ?= n". If I then just rebuild 
> xen.gz with "make debug=y" it works.

Pretty unusual - normally we'd expect more problems with debug=y
(because of extra checking done), not less.

> I'll keep fooling around and see if I can narrow this down any further.  So 
> my simple test fails with debug off, but I don't know if debug on just makes 
> it less likely to happen.  I'm going to run more extensive tests later.  I'll 
> also try to get a serial port setup on the box.

I'm afraid that's the only viable route.


Xen-devel mailing list



Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.