Re: [Xen-users] Using Ipv4 and IPv6 Subnet

["Simon Hobson" <linux@xxxxxxxxxxxxxxxx>]

Thore wrote:
>I have a xenbr0

Then there is nothing Xen-specific to set up

>Some time before I set this in my /etc/network/interfaces
>#iface eth0 inet6 static
>#  address 2a01:4f8:140:1:2
>#  netmask 64
>#  gateway fe80::1

fe80 addresses are self-assigned link-local, and you probably don't have an 
fe80::1 on the network. You need to set both a valid address and gateway. 
2a01:4f8:140:1:2 is not a valid IPv6 address - is there a typo there (too few 
groups, is there a :: missing) ?
The gateway might be configured by Route Advertisement broadcasts, or it might 
be configured manually - what does your hoster tell you to use ?

>At the moment it is inaktive.
>I have 3 IPv4 Adresses, no Subnet.

Actually, you will have a subnet, but most likely you have 3 IPs from a larger 
subnet shared with other hosting clients.

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxx
http://lists.xen.org/xen-users