Re: [Xen-users] How to use lvm stripe with xen?

[Ian Campbell <Ian.Campbell@xxxxxxxxxx>]

On Tue, 2012-04-17 at 15:57 +0100, Henning Ryll wrote:
> Hi,
> 
> I'm new on xen with only a very little experience :(
> 
> I have setup xen with "Citrix Xen Server 6.0" using one hard disk with only 
> 80 
> GB. Everything is running fine so far.
> 
> Now I have added two 1TB SATA disks.
> 
> Since Xen uses LVM it should be possible to use these 2 disks as lvm stripe 
> for performace reasons.
> But how to create local storage on these disks?
> 
> I am looking around but I can not find any samples to build al lvm stripe 
> with 
> 'xe sr-create'. All samples are using just 1 device.
> 
> How to create local storage using a lvm stipe ? 

If you are running XenServer then you should contact XenServer support
or use the XenServer forums on http://community.citrix.com/ so that they
can advise you on how to meet your requirements while still remaining
within the support envelope.

Ian.



_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxx
http://lists.xen.org/xen-users