Re: [Xen-users] Problems with xen and linux 2.26.32 kernels

["Fajar A. Nugraha" <fajar@xxxxxxxxx>]

On Thu, Jun 17, 2010 at 1:51 AM, Jia Rao <rickenrao@xxxxxxxxx> wrote:
> Hi all,
>
> I used to use xen 3.4.2 and linux 2.6.18-xen kernels for both dom0 and domU,
> without any problems.

You didn't mention which distro/version you use.

>
> Recently, I need to try io bandwidth control like dm-ioband in the new
> kernel 2.6.32 (dm-ioband has patches for this kernel). It gave me a lot of
> problems if I want to upgrade the dom0 to 2.6.32. The following is what I
> tried and the errors.

Any particular reason wanting to use 2.6.32? IMHO, the most "stable"
kernel-xen version out there is still currently RHEL's 2.6.18 kernel
(although it's missing some of newer Xen features)

>
>
> Xen: 3.4.3 (I need to stick with 3.4.x. 3.4.3 is the one that can run pvops)

You might want to try Xen 4.0. 3.4.3 might not have all the support
needed to run 2.6.32 kernel:
http://lists.xensource.com/archives/html/xen-users/2010-05/msg00879.html

>
> First approach:
> I tried to download pvops from the git repository xen/stable-2.6.32.x. The
> compilation was OK, but the initrd has a lot missing dependencies. I tried
> to use --builtin to claim those missing modules in kernel.

Did you actually have it built in? Missing usb modules are usually OK,
missing disk drivers are not.

> However, with the
> generated initrd, dom0 can not boot. I got the error: unable to locate
> IOAPIC for GSIx and mount: could not find filesystem: /dev/root.
> I enabled : CONFIG_SYSFS_DEPRECATED=y,  CONFIG_SYSFS_DEPRECATED_V2=y and
> tried to use root=/dev/sdax or root=LABEL=/. No luck.

It's best to start with known good kernel config (in my case it was
RHEL5's kernel-xen config), the add/adjust whatever's necessary in
newer kernel (including selecting pv_ops dom0 support). I use this
config on 2.6.32.13 pv_ops, on top of RHEL5, which works fine:
http://pastebin.com/5L44xXQj

>
> Second approach:
> Then I switched to the forward ported 2.6.32.13 kernel generated from the
> gentoo xen kernel patches.
>
> Still xen 3.4.3. After compilation, dom0 booted successfully. However I
> previous domU which has 2.6.18-xen kernels can not boot.

Any particular reason to switch domU to 2.6.32 as well?

> It has the same
> error: mount: could not find filesystem: /dev/root
> Do I need to create a initrd for the domU? I didnt need one when dom0 is
> 2.6.18-xen kernel.

It depends on kernel config and distro.

I prefer to use pygrub/pvgrub for domU kernels. That ensures domU is
somewhat independent of whatever kernel dom0 is running. In your case,
the easiest way would be to use 2.6.18-xen kernel for domU, while
using 2.6.32.x for dom0.

-- 
Fajar

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users