Re: [Xen-users] xen Live CD Login details required

[Thiago Camargo Martins Cordeiro <thiagocmartinsc@xxxxxxxxx>]

Hi,

 Users of all Xen Domains are "livexen" with password "live".
 You can use the command "sudo -s" to become root.

Regards,
Thiago

2009/11/23 Tapas Mishra <tapas@xxxxxxxxxxxx>

No it is not working I used the Live CD
I used the same to login to DomU

Login incorrect
client01 login: root
Password:





This is what I did
======================================

xenalive:/etc/xen# xm create -c client01.cfg name=ajk
Using config file "./client01.cfg".
Started domain ajk
1000 -> 0x00010000
[    0.000000]   HighMem  0x00010000 -> 0x00010000
[    0.000000] Movable zone start PFN for each node
[    0.000000] early_node_map[3] active PFN ranges
[    0.000000]     0: 0x00000000 -> 0x000000a0
[    0.000000]     0: 0x00000100 -> 0x000019b6
[    0.000000]     0: 0x000019f9 -> 0x00010000
[    0.000000] SMP: Allowing 1 CPUs, 0 hotplug CPUs
[    0.000000] Local APIC disabled by BIOS -- you can enable it with "lapic"
[    0.000000] PM: Registered nosave memory: 00000000000a0000 - 0000000000100000
[    0.000000] PM: Registered nosave memory: 00000000019b6000 - 00000000019f9000
[    0.000000] Allocating PCI resources starting at 20000000 (gap:
10000000:f0000000)
[    0.000000] PERCPU: Allocating 45852 bytes of per cpu data
[    0.000000] Xen: using vcpu_info placement
[    0.000000] Built 1 zonelists in Zone order, mobility grouping on.
Total pages: 64797
[    0.000000] Kernel command line: root=/dev/xvda1 aufs=tmpfs ro
console=tty0 guestname=client01
[    0.000000] Enabling fast FPU save and restore... done.
[    0.000000] Enabling unmasked SIMD FPU exception support... done.
[    0.000000] Initializing CPU#0
[    0.000000] PID hash table entries: 1024 (order: 10, 4096 bytes)
[    0.000000] Detected 2194.498 MHz processor.
[    0.010000] Console: colour dummy device 80x25
[    0.010000] console [tty0] enabled
[    0.010000] console [hvc0] enabled
[    0.010000] Dentry cache hash table entries: 32768 (order: 5, 131072 bytes)
[    0.010000] Inode-cache hash table entries: 16384 (order: 4, 65536 bytes)
[    0.010000] Memory: 232860k/262144k available (2631k kernel code,
28412k reserved, 1202k data, 440k init, 0k highmem)
[    0.010000] virtual kernel memory layout:
[    0.010000]     fixmap  : 0xf5478000 - 0xf57ff000   (3612 kB)
[    0.010000]     pkmap   : 0xf5000000 - 0xf5200000   (2048 kB)
[    0.010000]     vmalloc : 0xd0800000 - 0xf4ffe000   ( 583 MB)
[    0.010000]     lowmem  : 0xc0000000 - 0xd0000000   ( 256 MB)
[    0.010000]       .init : 0xc04c5000 - 0xc0533000   ( 440 kB)
[    0.010000]       .data : 0xc0391e86 - 0xc04be800   (1202 kB)
[    0.010000]       .text : 0xc0100000 - 0xc0391e86   (2631 kB)
[    0.010000] Checking if this processor honours the WP bit even in
supervisor mode...Ok.
[    0.010000] SLUB: Genslabs=12, HWalign=64, Order=0-3, MinObjects=0,
CPUs=1, Nodes=1
[    0.010000] installing Xen timer for CPU 0
[    0.010000] Calibrating delay loop (skipped), value calculated
using timer frequency.. 4388.99 BogoMIPS (lpj=21944980)
[    0.010000] Security Framework initialized
[    0.010000] SELinux:  Disabled at boot.
[    0.010000] AppArmor: AppArmor initialized
[    0.010000] Mount-cache hash table entries: 512
[    0.010000] Initializing cgroup subsys ns
[    0.010000] Initializing cgroup subsys cpuacct
[    0.010000] Initializing cgroup subsys memory
[    0.010000] CPU: L1 I cache: 32K, L1 D cache: 32K
[    0.010000] CPU: L2 cache: 2048K
[    0.010000] CPU: Physical Processor ID: 0
[    0.010000] CPU: Processor Core ID: 1
[    0.010000] SMP alternatives: switching to UP code
[    0.030000] Freeing SMP alternatives: 11k freed
[    0.030046] cpu 0 spinlock event irq 1
[    0.030166] Brought up 1 CPUs
[    0.030486] net_namespace: 840 bytes
[    0.030497] Booting paravirtualized kernel on Xen
[    0.030506] Xen version: 3.2-1
[    0.030676] Grant table initialized
[    0.050685] Time: 165:165:165  Date: 165/165/65
[    0.050744] NET: Registered protocol family 16
[    0.051206] EISA bus registered
[    0.051206] PCI: Fatal: No config space access function found
[    0.051877] ACPI: Interpreter disabled.
[    0.051886] Linux Plug and Play Support v0.97 (c) Adam Belay
[    0.051957] pnp: PnP ACPI: disabled
[    0.051965] PnPBIOS: Disabled
[    0.051979] xen_balloon: Initialising balloon driver.
[    0.051979] PCI: System does not support PCI
[    0.051979] PCI: System does not support PCI
[    0.051979] NET: Registered protocol family 8
[    0.051979] NET: Registered protocol family 20
[    0.051979] NetLabel: Initializing
[    0.051979] NetLabel:  domain hash size = 128
[    0.051979] NetLabel:  protocols = UNLABELED CIPSOv4
[    0.051979] NetLabel:  unlabeled traffic allowed by default
[    0.051979] tracer: 772 pages allocated for 65536 entries of 48 bytes
[    0.051979]    actual entries 65620
[    0.051979] AppArmor: AppArmor Filesystem Enabled
[    0.051979] NET: Registered protocol family 2
[    0.051979] IP route cache hash table entries: 2048 (order: 1, 8192 bytes)
[    0.051979] TCP established hash table entries: 8192 (order: 4, 65536 bytes)
[    0.051979] TCP bind hash table entries: 8192 (order: 4, 65536 bytes)
[    0.051979] TCP: Hash tables configured (established 8192 bind 8192)
[    0.051979] TCP reno registered
[    0.051979] NET: Registered protocol family 1
[    0.051979] checking if image is initramfs... it is
[    0.099292] Freeing initrd memory: 20264k freed
[    0.099734] platform rtc_cmos: registered platform RTC device (no
PNP device found)
[    0.100450] audit: initializing netlink socket (disabled)
[    0.100475] type=2000 audit(1258981353.643:1): initialized
[    0.106030] HugeTLB registered 2 MB page size, pre-allocated 0 pages
[    0.109434] VFS: Disk quotas dquot_6.5.1
[    0.109553] Dquot-cache hash table entries: 1024 (order 0, 4096 bytes)
[    0.109711] msgmni has been set to 551
[    0.109868] io scheduler noop registered
[    0.109877] io scheduler anticipatory registered
[    0.109885] io scheduler deadline registered (default)
[    0.109903] io scheduler cfq registered
[    0.110287] isapnp: Write Data Register 0xa79 already used
[    0.157968] Serial: 8250/16550 driver4 ports, IRQ sharing enabled
[    0.162344] brd: module loaded
[    0.162454] input: Macintosh mouse button emulation as
/devices/virtual/input/input0
[    0.162699] PNP: No PS/2 controller found. Probing ports directly.
[    0.163529] i8042.c: No controller found.
[    0.163884] mice: PS/2 mouse device common for all mice
[    0.164034] rtc_cmos: probe of rtc_cmos failed with error -16
[    0.164320] EISA: Probing bus 0 at eisa.0
[    0.164330] EISA: Cannot allocate resource for mainboard
[    0.164339] Cannot allocate resource for EISA slot 1
[    0.164348] Cannot allocate resource for EISA slot 2
[    0.164356] Cannot allocate resource for EISA slot 3
[    0.164364] Cannot allocate resource for EISA slot 4
[    0.164372] Cannot allocate resource for EISA slot 5
[    0.164380] Cannot allocate resource for EISA slot 6
[    0.164389] Cannot allocate resource for EISA slot 7
[    0.164397] Cannot allocate resource for EISA slot 8
[    0.164404] EISA: Detected 0 cards.
[    0.164412] cpuidle: using governor ladder
[    0.164419] cpuidle: using governor menu
[    0.164886] TCP cubic registered
[    0.164923] Using IPI No-Shortcut mode
[    0.165170] registered taskstats version 1
[    0.165189] XENBUS: Device with no driver: device/vkbd/0
[    0.165197] XENBUS: Device with no driver: device/vfb/0
[    0.165205] XENBUS: Device with no driver: device/vbd/51713
[    0.165213] XENBUS: Device with no driver: device/vif/0
[    0.165220] XENBUS: Device with no driver: device/console/0
[    0.165243]   Magic number: 1:252:3141
[    0.165323] /build/buildd/linux-2.6.27/drivers/rtc/hctosys.c:
unable to open rtc device (rtc0)
[    0.165335] BIOS EDD facility v0.16 2004-Jun-25, 0 devices found
[    0.165343] EDD information not available.
[    0.165592] Freeing unused kernel memory: 440k freed
[    0.166351] Write protecting the kernel text: 2632k
[    0.166631] Write protecting the kernel read-only data: 960k
[    0.299456] squashfs: version 3.3 (2007/10/31) Phillip Lougher
[    0.309023] aufs 20080922
[    0.334077] thermal: Unknown symbol acpi_processor_set_thermal_limit
[    0.473657] blkfront: xvda1: barriers enabled
[    6.283497] aufs test_add:423:mount[1795]: uid/gid/perm /ro
0/0/0755, 0/0/01777
[    6.755939] udevd version 124 started
[    7.480470] input: PC Speaker as /devices/platform/pcspkr/input/input1
[    7.488477] Console: switching to colour frame buffer device 100x37
[    7.502671] Initialising Xen virtual ethernet driver.
[    8.834440] input: Xen Virtual Keyboard as /devices/virtual/input/input2
[    8.900221] input: Xen Virtual Pointer as /devices/virtual/input/input3
[    9.212384] fuse init (API version 7.9)
[    9.250230] lp: driver loaded but no devices found

Ubuntu 8.10 client01 hvc0

client01 login: root
Password:

On Mon, Nov 23, 2009 at 1:07 PM, Boris Quiroz <boris.quiroz@xxxxxxxxxx> wrote:
> -----BEGIN PGP SIGNED MESSAGE-----
> Hash: SHA1
>
> Tapas Mishra wrote:
>> I want to know how can I login to the clients in Xen Live CD I
>> downloaded from Xen Website  I am not aware of the username and
>> passwords on Live CD
>>
> root and xensource??
> -----BEGIN PGP SIGNATURE-----
> Version: GnuPG v1.4.9 (GNU/Linux)
>
> iEYEARECAAYFAksKiSsACgkQGNJOcRr8JkJi9ACfQXhnTwvWNjFUCnlDunFq8AB4
> KLoAn0WQ2AMpf0+LGorkfu7AoTbi5g9v
> =u7+p
> -----END PGP SIGNATURE-----
>

--

http://www.abhitech.com

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users