|
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: [Xen-users] xen Live CD Login details required
No it is not working I used the Live CD I used the same to login to DomU Login incorrect client01 login: root Password: This is what I did ====================================== xenalive:/etc/xen# xm create -c client01.cfg name=ajk Using config file "./client01.cfg". Started domain ajk 1000 -> 0x00010000 [ 0.000000] HighMem 0x00010000 -> 0x00010000 [ 0.000000] Movable zone start PFN for each node [ 0.000000] early_node_map[3] active PFN ranges [ 0.000000] 0: 0x00000000 -> 0x000000a0 [ 0.000000] 0: 0x00000100 -> 0x000019b6 [ 0.000000] 0: 0x000019f9 -> 0x00010000 [ 0.000000] SMP: Allowing 1 CPUs, 0 hotplug CPUs [ 0.000000] Local APIC disabled by BIOS -- you can enable it with "lapic" [ 0.000000] PM: Registered nosave memory: 00000000000a0000 - 0000000000100000 [ 0.000000] PM: Registered nosave memory: 00000000019b6000 - 00000000019f9000 [ 0.000000] Allocating PCI resources starting at 20000000 (gap: 10000000:f0000000) [ 0.000000] PERCPU: Allocating 45852 bytes of per cpu data [ 0.000000] Xen: using vcpu_info placement [ 0.000000] Built 1 zonelists in Zone order, mobility grouping on. Total pages: 64797 [ 0.000000] Kernel command line: root=/dev/xvda1 aufs=tmpfs ro console=tty0 guestname=client01 [ 0.000000] Enabling fast FPU save and restore... done. [ 0.000000] Enabling unmasked SIMD FPU exception support... done. [ 0.000000] Initializing CPU#0 [ 0.000000] PID hash table entries: 1024 (order: 10, 4096 bytes) [ 0.000000] Detected 2194.498 MHz processor. [ 0.010000] Console: colour dummy device 80x25 [ 0.010000] console [tty0] enabled [ 0.010000] console [hvc0] enabled [ 0.010000] Dentry cache hash table entries: 32768 (order: 5, 131072 bytes) [ 0.010000] Inode-cache hash table entries: 16384 (order: 4, 65536 bytes) [ 0.010000] Memory: 232860k/262144k available (2631k kernel code, 28412k reserved, 1202k data, 440k init, 0k highmem) [ 0.010000] virtual kernel memory layout: [ 0.010000] fixmap : 0xf5478000 - 0xf57ff000 (3612 kB) [ 0.010000] pkmap : 0xf5000000 - 0xf5200000 (2048 kB) [ 0.010000] vmalloc : 0xd0800000 - 0xf4ffe000 ( 583 MB) [ 0.010000] lowmem : 0xc0000000 - 0xd0000000 ( 256 MB) [ 0.010000] .init : 0xc04c5000 - 0xc0533000 ( 440 kB) [ 0.010000] .data : 0xc0391e86 - 0xc04be800 (1202 kB) [ 0.010000] .text : 0xc0100000 - 0xc0391e86 (2631 kB) [ 0.010000] Checking if this processor honours the WP bit even in supervisor mode...Ok. [ 0.010000] SLUB: Genslabs=12, HWalign=64, Order=0-3, MinObjects=0, CPUs=1, Nodes=1 [ 0.010000] installing Xen timer for CPU 0 [ 0.010000] Calibrating delay loop (skipped), value calculated using timer frequency.. 4388.99 BogoMIPS (lpj=21944980) [ 0.010000] Security Framework initialized [ 0.010000] SELinux: Disabled at boot. [ 0.010000] AppArmor: AppArmor initialized [ 0.010000] Mount-cache hash table entries: 512 [ 0.010000] Initializing cgroup subsys ns [ 0.010000] Initializing cgroup subsys cpuacct [ 0.010000] Initializing cgroup subsys memory [ 0.010000] CPU: L1 I cache: 32K, L1 D cache: 32K [ 0.010000] CPU: L2 cache: 2048K [ 0.010000] CPU: Physical Processor ID: 0 [ 0.010000] CPU: Processor Core ID: 1 [ 0.010000] SMP alternatives: switching to UP code [ 0.030000] Freeing SMP alternatives: 11k freed [ 0.030046] cpu 0 spinlock event irq 1 [ 0.030166] Brought up 1 CPUs [ 0.030486] net_namespace: 840 bytes [ 0.030497] Booting paravirtualized kernel on Xen [ 0.030506] Xen version: 3.2-1 [ 0.030676] Grant table initialized [ 0.050685] Time: 165:165:165 Date: 165/165/65 [ 0.050744] NET: Registered protocol family 16 [ 0.051206] EISA bus registered [ 0.051206] PCI: Fatal: No config space access function found [ 0.051877] ACPI: Interpreter disabled. [ 0.051886] Linux Plug and Play Support v0.97 (c) Adam Belay [ 0.051957] pnp: PnP ACPI: disabled [ 0.051965] PnPBIOS: Disabled [ 0.051979] xen_balloon: Initialising balloon driver. [ 0.051979] PCI: System does not support PCI [ 0.051979] PCI: System does not support PCI [ 0.051979] NET: Registered protocol family 8 [ 0.051979] NET: Registered protocol family 20 [ 0.051979] NetLabel: Initializing [ 0.051979] NetLabel: domain hash size = 128 [ 0.051979] NetLabel: protocols = UNLABELED CIPSOv4 [ 0.051979] NetLabel: unlabeled traffic allowed by default [ 0.051979] tracer: 772 pages allocated for 65536 entries of 48 bytes [ 0.051979] actual entries 65620 [ 0.051979] AppArmor: AppArmor Filesystem Enabled [ 0.051979] NET: Registered protocol family 2 [ 0.051979] IP route cache hash table entries: 2048 (order: 1, 8192 bytes) [ 0.051979] TCP established hash table entries: 8192 (order: 4, 65536 bytes) [ 0.051979] TCP bind hash table entries: 8192 (order: 4, 65536 bytes) [ 0.051979] TCP: Hash tables configured (established 8192 bind 8192) [ 0.051979] TCP reno registered [ 0.051979] NET: Registered protocol family 1 [ 0.051979] checking if image is initramfs... it is [ 0.099292] Freeing initrd memory: 20264k freed [ 0.099734] platform rtc_cmos: registered platform RTC device (no PNP device found) [ 0.100450] audit: initializing netlink socket (disabled) [ 0.100475] type=2000 audit(1258981353.643:1): initialized [ 0.106030] HugeTLB registered 2 MB page size, pre-allocated 0 pages [ 0.109434] VFS: Disk quotas dquot_6.5.1 [ 0.109553] Dquot-cache hash table entries: 1024 (order 0, 4096 bytes) [ 0.109711] msgmni has been set to 551 [ 0.109868] io scheduler noop registered [ 0.109877] io scheduler anticipatory registered [ 0.109885] io scheduler deadline registered (default) [ 0.109903] io scheduler cfq registered [ 0.110287] isapnp: Write Data Register 0xa79 already used [ 0.157968] Serial: 8250/16550 driver4 ports, IRQ sharing enabled [ 0.162344] brd: module loaded [ 0.162454] input: Macintosh mouse button emulation as /devices/virtual/input/input0 [ 0.162699] PNP: No PS/2 controller found. Probing ports directly. [ 0.163529] i8042.c: No controller found. [ 0.163884] mice: PS/2 mouse device common for all mice [ 0.164034] rtc_cmos: probe of rtc_cmos failed with error -16 [ 0.164320] EISA: Probing bus 0 at eisa.0 [ 0.164330] EISA: Cannot allocate resource for mainboard [ 0.164339] Cannot allocate resource for EISA slot 1 [ 0.164348] Cannot allocate resource for EISA slot 2 [ 0.164356] Cannot allocate resource for EISA slot 3 [ 0.164364] Cannot allocate resource for EISA slot 4 [ 0.164372] Cannot allocate resource for EISA slot 5 [ 0.164380] Cannot allocate resource for EISA slot 6 [ 0.164389] Cannot allocate resource for EISA slot 7 [ 0.164397] Cannot allocate resource for EISA slot 8 [ 0.164404] EISA: Detected 0 cards. [ 0.164412] cpuidle: using governor ladder [ 0.164419] cpuidle: using governor menu [ 0.164886] TCP cubic registered [ 0.164923] Using IPI No-Shortcut mode [ 0.165170] registered taskstats version 1 [ 0.165189] XENBUS: Device with no driver: device/vkbd/0 [ 0.165197] XENBUS: Device with no driver: device/vfb/0 [ 0.165205] XENBUS: Device with no driver: device/vbd/51713 [ 0.165213] XENBUS: Device with no driver: device/vif/0 [ 0.165220] XENBUS: Device with no driver: device/console/0 [ 0.165243] Magic number: 1:252:3141 [ 0.165323] /build/buildd/linux-2.6.27/drivers/rtc/hctosys.c: unable to open rtc device (rtc0) [ 0.165335] BIOS EDD facility v0.16 2004-Jun-25, 0 devices found [ 0.165343] EDD information not available. [ 0.165592] Freeing unused kernel memory: 440k freed [ 0.166351] Write protecting the kernel text: 2632k [ 0.166631] Write protecting the kernel read-only data: 960k [ 0.299456] squashfs: version 3.3 (2007/10/31) Phillip Lougher [ 0.309023] aufs 20080922 [ 0.334077] thermal: Unknown symbol acpi_processor_set_thermal_limit [ 0.473657] blkfront: xvda1: barriers enabled [ 6.283497] aufs test_add:423:mount[1795]: uid/gid/perm /ro 0/0/0755, 0/0/01777 [ 6.755939] udevd version 124 started [ 7.480470] input: PC Speaker as /devices/platform/pcspkr/input/input1 [ 7.488477] Console: switching to colour frame buffer device 100x37 [ 7.502671] Initialising Xen virtual ethernet driver. [ 8.834440] input: Xen Virtual Keyboard as /devices/virtual/input/input2 [ 8.900221] input: Xen Virtual Pointer as /devices/virtual/input/input3 [ 9.212384] fuse init (API version 7.9) [ 9.250230] lp: driver loaded but no devices found Ubuntu 8.10 client01 hvc0 client01 login: root Password: On Mon, Nov 23, 2009 at 1:07 PM, Boris Quiroz <boris.quiroz@xxxxxxxxxx> wrote: > -----BEGIN PGP SIGNED MESSAGE----- > Hash: SHA1 > > Tapas Mishra wrote: >> I want to know how can I login to the clients in Xen Live CD I >> downloaded from Xen Website I am not aware of the username and >> passwords on Live CD >> > root and xensource?? > -----BEGIN PGP SIGNATURE----- > Version: GnuPG v1.4.9 (GNU/Linux) > > iEYEARECAAYFAksKiSsACgkQGNJOcRr8JkJi9ACfQXhnTwvWNjFUCnlDunFq8AB4 > KLoAn0WQ2AMpf0+LGorkfu7AoTbi5g9v > =u7+p > -----END PGP SIGNATURE----- > -- http://www.abhitech.com _______________________________________________ Xen-users mailing list Xen-users@xxxxxxxxxxxxxxxxxxx http://lists.xensource.com/xen-users
|
 |
Lists.xenproject.org is hosted with RackSpace, monitoring our |