Re: [Xen-devel] [PATCH v4 2/4] xen/arm: inflight irqs during migration

[Julien Grall <julien.grall@xxxxxxxxxx>]

On 06/11/2014 03:49 PM, Stefano Stabellini wrote:
> On Wed, 11 Jun 2014, Julien Grall wrote:
>> On 06/11/2014 03:15 PM, Stefano Stabellini wrote:
>>>>> +        {
>>>>> +            unsigned int irq, target, old_target;
>>>>> +            struct vcpu *v_target, *v_old;
>>>>> +
>>>>> +            target = i % 8;
>>>>> +
>>>>> +            irq = offset + (i / 8);
>>>>> +            v_target = v->domain->vcpu[target];
>>>>> +            old_target = byte_read(rank->itargets[REG_RANK_INDEX(8, 
>>>>> gicd_reg - GICD_ITARGETSR)], 0, i/8);
>>>>> +            v_old = v->domain->vcpu[old_target];
>>>>
>>>> v_target and v_old might be the same.
>>>
>>> No, they could not: if they were find_next_bit wouldn't find the bit set.
>>
>> Even though v_target is always != v_old (because of the tr = r & ~val
>> stuff), why do you migrate if the old_target will be in the new mask?
> 
> We need to be consistent: always the lowest vcpu in the mask.

It's not the case here. AFAIU tr only contains the list of VPCU that are
not yet in this register.

The old vcpu can have an cpuid lower than the new vcpu. In this case,
you won't respect your consistency.

Regards,

-- 
Julien Grall

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel