Re: [Xen-devel] [PATCH] doc: Better documentation about the usbdevice=['host:bus.addr'] format

[Ian Campbell <Ian.Campbell@xxxxxxxxxx>]

graft 15 <1390924983-4864-1-git-send-email-anthony.perard@xxxxxxxxxx>
thanks

On Tue, 2014-02-04 at 15:52 +0000, Ian Campbell wrote:
> On Tue, 2014-01-28 at 16:03 +0000, Anthony PERARD wrote:
> > Signed-off-by: Anthony PERARD <anthony.perard@xxxxxxxxxx>
> > ---
> >  docs/man/xl.cfg.pod.5 | 4 ++++
> >  1 file changed, 4 insertions(+)
> > 
> > diff --git a/docs/man/xl.cfg.pod.5 b/docs/man/xl.cfg.pod.5
> > index 9941395..9c0b438 100644
> > --- a/docs/man/xl.cfg.pod.5
> > +++ b/docs/man/xl.cfg.pod.5
> > @@ -1251,6 +1251,10 @@ Host devices can also be passed through in this way, 
> > by specifying
> >  host:USBID, where USBID is of the form xxxx:yyyy.  The USBID can
> >  typically be found by using lsusb or usb-devices.
> >  
> > +If you wish to use the "host:bus.addr" format, remove any leading '0' from 
> > the
> > +bus and addr. For example, for the USB device on bus 008 dev 002, you will
> > +write "host:8.2".
> 
> I tweaked this to "you should write...", then acked + applied.

There is an associated bug but I think it should remain open until the
underlying issue is fixed, rather than just documented as suggested
here.

If you think this issue should be closed please send email to xen-devel
+ bcc xen@xxxxxxxxxxxxxxxxxxx which begins:
        close 15
        thanks
(unindented)

Ian.


_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel