Re: [Xen-devel] which branch should be used as dom0 on arndale

[Julien Grall <julien.grall@xxxxxxxxxx>]

On 10/30/2013 02:57 PM, mail fetch wrote:
> 2013/10/30 mail fetch <fetchmail.0104@xxxxxxxxx
> <mailto:fetchmail.0104@xxxxxxxxx>>
>
>     Hi Julien,
Hello,


>     I found there are lots of branches under linux-arm.git. Xen wiki
>     recommends to use branch arndale. But i found it lacks of the
>     following configuration in dts file which is exist in branch
>     arndale-dom0-3.10. Should i use arndale or arndale-dom0-3.10 as dom0?
>     Can Xen boot up without those configuration?
U-boot will automatically create the nodes in the device tree with the 
following script:
http://xenbits.xen.org/people/julieng/load-xen-tftp.scr.txt
All details are given by the wiki page.

>     chosen {
>                     bootargs = "dom0_mem=256M sync_console console=dtuart
>     dtuart=serial2 earlyprintk=xen";
>                     xen,dom0-bootargs = "console=hvc0,115200n8
>     earlyprintk=xen debug ignore_loglevel psci=enable clk_ignore_unused
>     root=/dev/mmcblk1p2";
>                     modules {
>                             module@0 {
>                                     compatible = "xen,linux-zimage",
>     "xen,multiboot-module";
>                                     reg = <0x60000000 0x500000>;
>                             };
>                     };
>             };
>
>     --
>     best regards
>     Mail
>
>
> Any ideas?
You should avoid to ping after only a couple of hours... we can work in 
a different timezone or be away for conferences/holidays.
I think 1 week is the minimum delay between 2 pings.

Cheers,

--
Julien Grall

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel