[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: [Xen-devel] dom0 won't boot
On Thursday 29 July 2004 08:29 pm, Ian Pratt wrote: > All of that output is from grub, you're not seeing anything from > Xen. > > Try "com1=115200,8n1" and make sure that you've got the baudrate > at the other end set correctly (I thought grub defaulted to 9600?) It's set correctly -- I had never done this before, so there was a bit of a learning curve. I practiced on the smp kernel that I usually boot into and when I was able to capture everything in minicom there I switched over to xen. If I had gotten no output at all, it would have been suspicious. However, I did get output, no characters were garbled, no sentences cut in half, etc. For whatever it's worth, here's the entry in grub: title Xen-Serial serial --unit=0 --speed=9600 --word=8 --parity=no --stop=1 terminal serial kernel (hd0,4)/boot/xen.gz dom0_mem=131072 com1=115200 noht noreboot module (hd0,4)/boot/vmlinuz-2.4.26-xen0 root=/dev/sda5 ro console=ttyS0 But still, a good point. Barry > > Ian ------------------------------------------------------- This SF.Net email is sponsored by OSTG. Have you noticed the changes on Linux.com, ITManagersJournal and NewsForge in the past few weeks? Now, one more big change to announce. We are now OSTG- Open Source Technology Group. Come see the changes on the new OSTG site. www.ostg.com _______________________________________________ Xen-devel mailing list Xen-devel@xxxxxxxxxxxxxxxxxxxxx https://lists.sourceforge.net/lists/listinfo/xen-devel
|
![]() |
Lists.xenproject.org is hosted with RackSpace, monitoring our |