RE: [Xen-API] Do we have API support for open vswitch

[Rob Hoes <Rob.Hoes@xxxxxxxxxx>]

As far as I know, the open vswitch backend should have been enabled by default. 
If that was not the case, something might have gone wrong.

Jon: any idea?

In any case, you can indeed enable the open vswitch by executing the 
xe-switch-network-backend command.

Cheers,
Rob

> -----Original Message-----
> From: xen-api-bounces@xxxxxxxxxxxxxxxxxxx [mailto:xen-api-
> bounces@xxxxxxxxxxxxxxxxxxx] On Behalf Of frank
> Sent: 11 December 2010 00:26
> To: George Shuklin
> Cc: xen-api@xxxxxxxxxxxxxxxxxxx
> Subject: Re: [Xen-API] Do we have API support for open vswitch
> 
>   I just notice we can switch to open vswitch by "xe-switch-network
> backend openvswitch"
> but not sure if any API for vswitch control.
> 
> > This is really strange, but in XCP 1.0b1 they do not use Open vSwitch.
> I
> > don't know why, but that was unexpected...
> >
> >
> > Ð ÐÑÐ, 10/12/2010 Ð 11:09 -0800, frank ÐÐÑÐÑ:
> >> Hi experts:
> >>       Did we already add API support for open vswitch? something
> like
> >> create bridge, add interface, set up
> >> GRE tunnel, connect switch to openflow controller ...
> >>
> >>       I am using XenServer5.6 FP1? Where I can find the API
> documentations?
> >>
> >
> >
> > _______________________________________________
> > xen-api mailing list
> > xen-api@xxxxxxxxxxxxxxxxxxx
> > http://lists.xensource.com/mailman/listinfo/xen-api
> 
> 
> --
> Frank Zhang
> Cloud.com INC
> 
> 
> _______________________________________________
> xen-api mailing list
> xen-api@xxxxxxxxxxxxxxxxxxx
> http://lists.xensource.com/mailman/listinfo/xen-api

_______________________________________________
xen-api mailing list
xen-api@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/mailman/listinfo/xen-api