'tail -100 audit.log' information is in the attach "audit_100.log".
And I have disabled the selinux as fellow:
# This file controls the state of SELinux on the system.
# SELINUX= can take one of these three values:
# enforcing - SELinux security policy is enforced.
# permissive - SELinux prints warnings instead of enforcing.
# disabled - No SELinux policy is loaded.
SELINUX=disabled
# SELINUXTYPE= can take one of three two values:
# targeted - Targeted processes are protected,
# minimum - Modification of targeted policy. Only selected processes are protected.
# mls - Multi Level Security protection.
SELINUXTYPE=targeted
--
-------------------------------------------------------------------
孙鄂雄 上海大学
联系方式: +86-13732252150
电子邮箱: sunexiong@163.com
联系地址: 上海大学宝山校区上大路99号校内
At 2017-03-08 00:26:58, "George Dunlap" <george.dunlap@xxxxxxxxxx> wrote:
>On 07/03/17 16:10, 孙鄂雄 wrote:
>> I compiled xen-4.8 from source in my centos7. I chosen linux 4.9.13 as the Dom0. And I use make xenconfig commond to compile the Dom0 kernel. After I complete these steps. I boot the centos 7 with xen.
>> xl info and xl list works.It seems everything is ok.
>> But when I start xencommons, something wrong with it.
>>
>>
>> # /etc/init.d/xencommons start
>> Setting domain 0 name, domid and JSON config...
>> Dom0 is already set up
>> Starting xenconsoled...
>> Starting QEMU as disk backend for dom0
>> qemu-system-i386: could not acquire pid file: Resource temporarily unavailable
>>
>>
>> I check the boot log, and I found
>> Mar 04 09:42:53 localhost.localdomain systemd[1]: Failed to start Load Kernel Modules.
>> Then, I use command: /usr/lib/systemd/systemd-modules-load
>> It shows:
>> Module 'xen_evtchn' is builtin
>> Module 'xen_gntdev' is builtin
>> Failed to find module 'evtchn'
>> Failed to find module 'gntdev'
>> Failed to find module 'netbk'
>> Failed to find module 'blkbk'
>> Failed to find module 'xen-scsibk'
>> Failed to find module 'usbbk'
>> Failed to find module 'pciback'
>> Failed to find module 'blktap2'
>>
>> The attach is dmesg information and the xl dmesg information.
>>
>> /var/log/audit/audit.log file is too big to upload.
>
>Thanks -- could you then do 'tail -100 audit.log' just after you try
>running xencommons?
>
>Also, just checking -- it appears you're running xencommons by hand, is
>that right?
>
>Is there a reason you're running the SysV version of xencommons rather
>than using the systemd startup files? (see INSTALL for how to use and
>enable the systemd scripts)
>
>Finally -- probably the first thing to do is to see if disabling SELinux
>affects anything. You can do this by modifying /etc/ selinux/config and
>setting SELINUX=permissive.
>
>Thanks!
> -George
>
