Re: [Xen-users] PROBLEM: Kernel BUG with raid5 soft + Xen + DRBD - invalid opcode

[MasterPrenium <masterprenium.lkml@xxxxxxxxx>]

Hi Shaohua,

I've made some new little tests, maybe it can help.

- I tried creating the RAID 5 stack with only 2 drives (mdadm --create 
/dev/md10 --raid-devices=3 --level=5 /dev/sdc1 /dev/sdd1 missing).
The same issue is happening.
- but one time (still with 2/3 drives), I was not able to crash the 
kernel, with exactly the same procedure as previous. Even with 
re-creating filesystems ect.
In order to re-produce the BUG I had to re-create the array.

Can this be linked to this message ? :
[  155.667456] md10: Warning: Device sdc1 is misaligned

I don't know how to "align" a drive in a RAID stack... The partition is 
correctly align (as "parted" says).
- In another test (still 2/3 drives in the stack), I didn't got the 
kernel crash, but I had 100% io wait on cpu. Trying to reboot, finally 
give me this printk messages : http://pastebin.com/uzVHUUrC
If you have any patch to give me (maybe something to be more verbose 
about the issue), please tell me, I'll test it as it's a really blocking 
issue...
Best regards,

MasterPrenium


Le 09/01/2017 à 23:44, Shaohua Li a écrit :
> On Sun, Jan 08, 2017 at 02:31:15PM +0100, MasterPrenium wrote:
> > Hello,
> >
> > Replies below + :
> > - I don't know if this can help but after the crash, when the system
> > reboots, the Raid 5 stack is re-synchronizing
> > [   37.028239] md10: Warning: Device sdc1 is misaligned
> > [   37.028541] created bitmap (15 pages) for device md10
> > [   37.030433] md10: bitmap initialized from disk: read 1 pages, set 59 of
> > 29807 bits
> >
> > - Sometimes the kernel completely crash (lost serial + network connection),
> > sometimes only got the "BUG" dump, but still have network access (but a
> > reboot is impossible, need to reset the system).
> >
> > - You can find blktrace here (while running fio), I hope it's complete since
> > the end of the file is when the kernel crashed : https://goo.gl/X9jZ50
> Looks most are normal full stripe writes.
>   
> > > I'm trying to reproduce, but no success. So
> > > ext4->btrfs->raid5, crash
> > > btrfs->raid5, no crash
> > > right? does subvolume matter? When you create the raid5 array, does adding
> > > '--assume-clean' option change the behavior? I'd like to narrow down the issue.
> > > If you can capture the blktrace to the raid5 array, it would be great to hint
> > > us what kind of IO it is.
> > Yes Correct.
> > The subvolume doesn't matter.
> > -- assume-clean doesn't change the behaviour.
> so it's not a resync issue.
>
> > Don't forget that the system needs to be running on xen to crash, without
> > (on native kernel) it doesn't crash (or at least, I was not able to make it
> > crash).
> > > > Regarding your patch, I can't find it. Is it the one sent by Konstantin
> > > > Khlebnikov ?
> > > Right.
> > It doesn't help :(. Maybe the crash is happening a little bit later.
> ok, the patch is unlikely helpful, since the IO size isn't very big.
>
> Don't have good idea yet. My best guess so far is virtual machine introduces
> extra delay, which might trigger some race conditions which aren't seen in
> native.  I'll check if I could find something locally.
>
> Thanks,
> Shaohua

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxx
https://lists.xen.org/xen-users