Re: [Xen-users] [xen-4.6-ARM][Renesas-Lager Board] Fail to enter rootfs on DOM0 after setting XEN

[Julien Grall <julien.grall@xxxxxxxxxx>]

On 29/10/15 09:35, ììí wrote:
> Hello, 

Hello,

> After setting xen, DOM0 stop before find rootfs. In case of without-xen,
> rootfs  was found. But In case of with-xen, DOM0 was hold with bootargs
> like below.
> 
> xen,dom0-bootargs = "console=hvc0 earlyprintk=xen debug ignore_loglevel
> vmalloc=384M video=HDMI-A-1:1920x1080-32@60
> ip=192.168.0.91:192.168.0.228:192.168.0.1:255.255.255.0:lager:eth0:::
> root=/dev/nfs rw nfsroot=192.168.0.228:/nfsroot/lager, nfsvers=3
> rootdelay clk_ignore_unused";

Before trying to use an NFS rootfs, did you check that the network
device is fully working on Xen?

If not, I would advice to start by looking at this before trying more
complex setup.

Regards,

-- 
Julien Grall

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxx
http://lists.xen.org/xen-users