Re: [Xen-users] NPIV + Multipath

[Nick Couchman <nick.couchman@xxxxxxxxx>]

----- Original Message -----
> From: "Etzion Bar-Noy" <etzion@xxxxxxxxxxxx>
> To: "Nick Couchman" <nick.couchman@xxxxxxxxx>
> Cc: eneal@xxxxxxxxxxxxxxxxx, xen-users@xxxxxxxxxxxxxxxxxxx
> Sent: Monday, September 22, 2014 1:21:09 PM
> Subject: Re: [Xen-users] NPIV + Multipath
> 
> 
> Just a note - multipath does not use SCSI ID, but uses Word 83. I
> hope it helps you with your search.
> 
> Etzion
> 
> 

The multipath configuration I have by default uses the following binary as the 
"getuid_callout" for determining paths:
/lib/udev/scsi_id

Based on the name of that binary, I was guessing it uses scsi_id.  In any case, 
I'm open to suggestions on what to replace the "getuid_callout" setting with 
that would work inside a Xen domU.  If there's something else that is able to 
reliably determine multiple paths to a disk other than the above scsi_id 
(whatever it uses), I would be interested to know.  I thought about using dd to 
input the X bytes of the disk, then run that through some sort checksum (shasum 
or something like that), but I'm not familiar enough to know if that would 
actually be reliable.

Thanks,
Nick

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxx
http://lists.xen.org/xen-users