|
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: [Xen-users] Can't boot converted SLES11SP2/OES11 domU
On 12/14/2013 1:54 PM, James Pifer wrote: I have a physical SLES11SP2/OES11 system that I've converted to a domU. It's boots ok as an HVM, but when I try to boot as a PV it gets stuck. I have the kernel-xen packages installed and confident the menu.lst is correct.If I look at xm console for the VM I get the output below: Any ideas? Thanks James [ 0.000000] Initializing cgroup subsys cpuset [ 0.000000] Initializing cgroup subsys cpu[ 0.000000] Linux version 3.0.101-0.5-xen (geeko@buildhost) (gcc version 4.3.4 [gcc-4_3-branch revision 152973] (SUSE Linux) ) #1 SMP Thu Oct 31 05:21:34 UTC 2013 (36fae46) [ 0.000000] Command line: root=/dev/xvda2 resume=/dev/xvda1 splash=silent showopts vga=0x317[ 0.000000] Xen-provided physical RAM map: [ 0.000000] Xen: 0000000000000000 - 0000000100800000 (usable) [ 0.000000] NX (Execute Disable) protection: active [ 0.000000] last_pfn = 0x100800 max_arch_pfn = 0x80000000 [ 0.000000] last_pfn = 0x100000 max_arch_pfn = 0x80000000 [ 0.000000] init_memory_mapping: 0000000000000000-0000000100000000 [ 0.000000] init_memory_mapping: 0000000100000000-0000000100800000 [ 0.000000] nmi ring buffer: 262144 [ 0.000000] RAMDISK: 00880000 - 019ac000 [ 0.000000] ACPI in unprivileged domain disabled [ 0.000000] Zone PFN ranges: [ 0.000000] DMA 0x00000000 -> 0x00001000 [ 0.000000] DMA32 0x00001000 -> 0x00100000 [ 0.000000] Normal 0x00100000 -> 0x00100800 [ 0.000000] Movable zone start PFN for each node [ 0.000000] early_node_map[2] active PFN ranges [ 0.000000] 0: 0x00000000 -> 0x00100000 [ 0.000000] 0: 0x00100800 -> 0x00100800 [ 0.000000] Normal zone: 28 pages exceeds realsize 0[ 0.000000] setup_percpu: NR_CPUS:512 nr_cpumask_bits:512 nr_cpu_ids:4 nr_node_ids:1 [ 0.000000] PERCPU: Embedded 18 pages/cpu @ffff8800fbc00000 s41088 r8192 d24448 u524288 [ 0.000000] Swapping MFNs for PFN 728 and fbc05 (MFN 2b36a00 and da036c) [ 0.000000] Built 1 zonelists in Zone order, mobility grouping on. Total pages: 1034240 [ 0.000000] Kernel command line: root=/dev/xvda2 resume=/dev/xvda1 splash=silent showopts vga=0x317[ 0.000000] bootsplash: silent mode. [ 0.000000] PID hash table entries: 4096 (order: 3, 32768 bytes)[ 0.000000] Dentry cache hash table entries: 524288 (order: 10, 4194304 bytes) [ 0.000000] Inode-cache hash table entries: 262144 (order: 9, 2097152 bytes)[ 0.000000] allocated 33619968 bytes of page_cgroup[ 0.000000] please try 'cgroup_disable=memory' option if you don't want memory cgroups[ 0.000000] Software IO TLB disabled[ 0.000000] Memory: 4054728k/4202496k available (4121k kernel code, 8192k absent, 139576k reserved, 3171k data, 424k init)[ 0.000000] Hierarchical RCU implementation. [ 0.000000] RCU dyntick-idle grace-period acceleration is enabled. [ 0.000000] NR_IRQS:38912 nr_irqs:2624 16 [ 0.000000] Xen reported: 2494.062 MHz processor. [ 0.000000] Console: colour dummy device 80x25 [ 0.000000] console [tty0] enabled [ 0.000000] console [xvc-1] enabled[ 0.080007] Calibrating delay using timer specific routine.. 5055.20 BogoMIPS (lpj=10110411)[ 0.080015] pid_max: default: 32768 minimum: 301 [ 0.080080] Security Framework initialized [ 0.080098] AppArmor: AppArmor initialized [ 0.080121] Mount-cache hash table entries: 256 [ 0.080232] Initializing cgroup subsys cpuacct [ 0.080239] Initializing cgroup subsys memory [ 0.080247] Initializing cgroup subsys devices [ 0.080250] Initializing cgroup subsys freezer [ 0.080253] Initializing cgroup subsys net_cls [ 0.080256] Initializing cgroup subsys blkio [ 0.080263] Initializing cgroup subsys perf_event [ 0.080317] ENERGY_PERF_BIAS: Set to 'normal', was 'performance'[ 0.080318] ENERGY_PERF_BIAS: View and update with x86_energy_perf_policy(8)[ 0.080368] SMP alternatives: switching to UP code [ 0.109517] Brought up 1 CPUs [ 0.109606] devtmpfs: initialized [ 0.109870] print_constraints: dummy: [ 0.130004] Time: 165:165:165 Date: 165/165/65 [ 0.130066] NET: Registered protocol family 16 [ 0.130211] SMP alternatives: switching to SMP code [ 0.158810] Brought up 4 CPUs [ 0.160017] PCI: Fatal: No config space access function found [ 0.160024] PCI: setting up Xen PCI frontend stub [ 0.160311] bio: create slab <bio-0> at 0 [ 0.160322] ACPI: Interpreter disabled. [ 0.160322] vgaarb: loaded [ 0.160322] suspend: event channel 15 [ 0.160322] xen_mem: Initialising balloon driver. [ 0.160322] Unable to read sysrq code in control/sysrq [ 0.160322] PCI: System does not support PCI [ 0.160322] PCI: System does not support PCI [ 0.160322] NetLabel: Initializing [ 0.160322] NetLabel: domain hash size = 128 [ 0.160322] NetLabel: protocols = UNLABELED CIPSOv4 [ 0.160322] NetLabel: unlabeled traffic allowed by default [ 0.160322] Switching to clocksource xen [ 0.160805] Switched to NOHz mode on CPU #0 [ 0.162490] AppArmor: AppArmor Filesystem Enabled [ 0.162490] pnp: PnP ACPI: disabled [ 0.162668] NET: Registered protocol family 2[ 0.162767] IP route cache hash table entries: 131072 (order: 8, 1048576 bytes)[ 0.163243] Switched to NOHz mode on CPU #1[ 0.163257] TCP established hash table entries: 262144 (order: 10, 4194304 bytes) [ 0.163832] TCP bind hash table entries: 65536 (order: 8, 1048576 bytes)[ 0.163889] Switched to NOHz mode on CPU #2[ 0.163992] TCP: Hash tables configured (established 262144 bind 65536)[ 0.163996] TCP reno registered [ 0.164000] UDP hash table entries: 2048 (order: 5, 131072 bytes) [ 0.164024] UDP-Lite hash table entries: 2048 (order: 5, 131072 bytes) [ 0.164216] NET: Registered protocol family 1 [ 0.164269] Unpacking initramfs... [ 0.164288] Switched to NOHz mode on CPU #3 [ 0.176390] Freeing initrd memory: 17584k freed [ 0.181881] audit: initializing netlink socket (disabled) [ 0.181906] type=2000 audit(1387044947.180:1): initialized [ 0.207507] bounce pool size: 64 pages [ 0.207872] VFS: Disk quotas dquot_6.5.2 [ 0.207923] Dquot-cache hash table entries: 512 (order 0, 4096 bytes) [ 0.207990] msgmni has been set to 2056 [ 0.208179] alg: No test for stdrng (krng)[ 0.208221] Block layer SCSI generic (bsg) driver version 0.4 loaded (major 253)[ 0.208262] io scheduler noop registered [ 0.208265] io scheduler deadline registered [ 0.208290] io scheduler cfq registered (default) [ 0.208515] Non-volatile memory driver v1.3 [ 0.208581] Xen virtual console successfully installed as xvc0 [ 0.209826] bootsplash 3.2.0-2010/03/31: looking for picture... [ 0.209828] bootsplash: silentjpeg size 59221 bytes [ 0.225712] bootsplash: scaling image from 1024x768 to 800x600 [ 0.250385] bootsplash: scaling image from 1024x768 to 800x600 [ 0.267722] Console: switching to colour frame buffer device 96x33 [ 0.274853] bootsplash: scaling image from 1024x768 to 800x600 [ 0.299383] bootsplash: scaling image from 1024x768 to 800x600 [ 0.320686] console [tty0] enabled[ 0.321576] input: Xen Virtual Keyboard as /devices/virtual/input/input0 [ 0.321632] input: Xen Virtual Pointer as /devices/virtual/input/input1[ 0.328722] Fixed MDIO Bus: probed[ 0.328779] i8042: PNP: No PS/2 controller found. Probing ports directly.[ 1.346241] i8042: No controller found [ 1.346405] mousedev: PS/2 mouse device common for all mice [ 1.346581] EFI Variables Facility v0.08 2004-May-17 [ 1.346816] TCP cubic registered [ 1.346854] Registering the dns_resolver key type [ 1.346967] registered taskstats version 1 [ 1.347011] Magic number: 1:252:3141 [ 1.347070] XENBUS: Device with no driver: device/vbd/51712 [ 1.347096] XENBUS: Device with no driver: device/vif/0 [ 1.347307] Freeing unused kernel memory: 424k freed [ 1.347513] Write protecting the kernel read-only data: 6888k [ 1.405949] SCSI subsystem initialized [ 1.406566] HP CISS Driver (v 4.6.28) [ 1.444007] netfront: Initialising virtual ethernet driver. [ 1.561718] xen-vbd: registered block device major 202 [ 1.561805] blkfront: xvda: flush diskcache: enabled [ 1.563164] xvda: xvda1 xvda2 [ 1.665025] rdac: device handler registered [ 1.672330] hp_sw: device handler registered [ 1.679412] emc: device handler registered [ 1.686872] alua: device handler registered [ 1.691116] udev: starting version 147 [ 2.004010] kjournald starting. Commit interval 15 seconds [ 2.016756] EXT3-fs (xvda2): using internal journal [ 2.016786] EXT3-fs (xvda2): mounted filesystem with ordered data mode _______________________________________________ Xen-users mailing list Xen-users@xxxxxxxxxxxxx http://lists.xen.org/xen-users Disregard. Was able to get this working. Had to force a mkinitrd by booting with virt-manager to /dev/xvda. James _______________________________________________ Xen-users mailing list Xen-users@xxxxxxxxxxxxx http://lists.xen.org/xen-users
|
 |
Lists.xenproject.org is hosted with RackSpace, monitoring our |