Re: [Xen-users] [Xen-devel] some problem with XSM enable

[Daniel De Graaf <dgdegra@xxxxxxxxxxxxx>]

On 06/03/2013 11:32 PM, quan.xu@xxxxxxxxxx wrote:
> hi community
> when I want to enable XSM for vtpm, there are some problems in xen boot up.
> Xen version  xen-4.3.0-rc2, dom0 is linux-3.7.10 without tpm drivers. I 
> configure xen-source-tree/Config.mk
>
> XSM_ENABLE ?= y
> FLASK_ENABLE ?= $(XSM_ENABLE)
>
> And make dist, make install
> Then I make the policy in xen-source-tree:  make -C tools/flask/policy
>
> When XSM is enabled, the xen boot-up stops at a lot of hex printout:
This looks like a crash, in which case the interesting parts would be
above the hex - which you didn't copy very accurately.  If possible,
using a serial console will be helpful in getting the text without
needing to retype output.

The most important part is the value of RIP and the backtrace (if one
is present); log messages leading up to the crash may also be useful.

> > > > >
> Fff82*********** Fff82***********  Fff82***********
> ~  ~  ~ ~ ~~ ~~ ~  ~  ~ ~ ~ ~ ~ ~~~~~~ ~~~~~~~~~~~~~ ~
> 000000000000000 000000000000000  0000000000000000
> 000000000000000 0000000000fff000  0000000000000000
> <<<<
> I make sure if "XSM_ENABLE ?= n and  FLASK_ENABLE ?= $(XSM_ENABLE)", the xen 
> can work properly.
>
> Thanks
>
> Quan Xu
xen-users dropped to BCC

--
Daniel De Graaf
National Security Agency

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxx
http://lists.xen.org/xen-users