Re: [Xen-users] [Xen-devel] Xen Source code build

[Mohit Dhingra <mohitdhingras@xxxxxxxxx>]

Thanks Ian,

After I inserted evtchn.ko, xenstored started fine and then xencommons script.

----------------------------

Thanks & Regards
Mohit Dhingra 
+919611190435

On 7 April 2012 16:43, Ian Campbell <Ian.Campbell@xxxxxxxxxx> wrote:

On Sat, 2012-04-07 at 12:04 +0100, Mohit Dhingra wrote:
> Hi Ian/All,
>

> Thanks for your prompt reply.
>
> No, I didn't remove the earlier Xen version earlier, but now I have
> done so, and installed the new Xen4.1.2 again.
>
> "xm" commands are still not running, Using "xl" commands, I get the
> following error:
>
> cadlab:/srv/xen-4.1.2 # xl list
> libxl: error: libxl.c:56:libxl_ctx_init Is xenstore daemon running?
> failed to stat /var/run/xenstored.pid: No such file or directory
> cannot init xl context

You need to arrange for the "xencommons" initscript to run on boot.

> cadlab:/srv/xen-4.1.2 # xenstored
> cadlab:/srv/xen-4.1.2 # FATAL: Failed to open evtchn device: No such
> file or directory

You need to load the xen-evtch module. xencommons would have done this
for you.

Ian.

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxx
http://lists.xen.org/xen-users