Re: [Xen-users] XCP 1.0 Network Interfaces missing on pool slave after relocation

[Mike Galvez <late2werk@xxxxxxxxx>]

After more searching, I found a post that mentioned re-IPing a pool master caused a similar problem. xsconsole didn't show any interfaces, so via command line, I edited the network config and changed the IP. I was able to ssh into the machine at this point, and run [ xe pool-emergency-reset-master master-address=xxx.xx.xx.xx ] and then [ xe pif-reconfigure-ip ]. After pif-reconfigure, the machine was unresponsive and had to be rebooted, but when it came back up it was fully functional again. 

This machine and the master are both running XCP1.1.0-48877c (beta), so I made another trip to the data center to upgrade to 1.1 Release. After booting the slave with 1.1 Release CD, I got a message that no upgradeable operating system was found (not the exact error message) and that I would need to perform a fresh install?  I was under the impression that upgrading from 1.1 beta to 1.1 Release was almost painless. Does this have to be done on the master first?  Any ideas?

Thanks

On Tue, Nov 15, 2011 at 5:49 PM, Mike Galvez <late2werk@xxxxxxxxx> wrote:

I relocated my hosts to a new data center. The pool master booted fine and I changed the management IP and VMs started fine as well. The slave host started, but it doesn't show to have any NICs. If I exit to a command line I can list them with ifconfig, but none show up in xsconsole. I can also see chatter on the NIC LEDs and the switch ports. I didn't find any helpful old posts here or on the Citrix site.

 

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users