[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [Xen-users] Failed to setup NAT
I'm using Xen 4.1 and here's what I did: 1.comment network-script and vif-script about bridge in /etc/xen/xend-config.sxp, uncomment the lines about nat 2.set vm config, add something likeÂvif = [ 'mac=00:16:3e:00:00:11, ip=10.0.0.1' ]
3.set /etc/network/interfaces in domU, add lines as follows: auto eth0 iface eth0 inet static address 10.0.0.1 gateway 10.0.0.254 netmask 255.255.255.0 But it didn't work! Here's the output of "ifconfig -a" in dom0 tap10.0  Link encap:Ethernet ÂHWaddr a6:8a:1b:92:be:af       BROADCAST MULTICAST ÂMTU:1500 ÂMetric:1
     RX packets:0 errors:0 dropped:0 overruns:0 frame:0      TX packets:0 errors:0 dropped:0 overruns:0 carrier:0      collisions:0 txqueuelen:500      RX bytes:0 (0.0 B) ÂTX bytes:0 (0.0 B)
vif10.0  Link encap:Ethernet ÂHWaddr fe:ff:ff:ff:ff:ff       BROADCAST MULTICAST ÂMTU:1500 ÂMetric:1      RX packets:0 errors:0 dropped:0 overruns:0 frame:0      TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
     collisions:0 txqueuelen:32      RX bytes:0 (0.0 B) ÂTX bytes:0 (0.0 B) the vif10.0 didn't get an ip! The same thing happened in domU whose eth0 didn't get ip, too. Strangely, eth0 was renamed to eth9, I don't know why.
So, where did I make mistake? How to setup NAT network in the new toolstack? By the way, can I use bridge mode if I have only one IP?
_______________________________________________ Xen-users mailing list Xen-users@xxxxxxxxxxxxxxxxxxx http://lists.xensource.com/xen-users
|
Lists.xenproject.org is hosted with RackSpace, monitoring our |