Re: [Xen-users] Bringing up management interfaces xenbr0...RTL8169

[Mike Wright <mike.wright@xxxxxxxxxxxxxx>]

On 05/24/2011 06:10 PM, Julio Cesar Batista de Oliveira wrote:
> Hi everybody!
> I had install XCP 1.0.0 in my AMD64 server. I configured my first
> dom0, but now i can't access my XCP server. I set up my interfaces in
> XCP with fixed or DHCP (Network and Management Interface) but i can't
> get access, ping...
> My network driver is RTL8111/8168B PCI Express Gigabit Ethernet (on
> board), and 2 RTL-8169 gigabit (off board).
> I'm getting a error ...something like that:
> Bringing up management interfaces xenbr0: cannot set large receive
> offload settings: Operation not supported...
> I don't know if it's the reason...
> Any help is appreciated..
I just bought a Gigabyte mobo with an AMD64 that also has the 8111/8168 
onboard network controller.  With Fedora14 and 15 the driver chosen is 
for the 8169.  Pinging results in 40% dropped packets and regular use is 
erratic with lots of retransmits.  It is not usable.
I don't know if the problem lies with the chip or the driver.  "ethtool 
-p eth0" reports "Cannot identiry NIC: Operation not supported".
This sounds similar to your situation.

hth,
Mike Wright

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users