Re: [Xen-users] trouble installing

["Fajar A. Nugraha" <list@xxxxxxxxx>]

On Fri, Feb 25, 2011 at 3:13 AM, Ted Brenner <griztown@xxxxxxxxx> wrote:
> Thanks for your help and patience everyone.  I set up the interfaces file as
> described and everything worked.  The only note is the pan0 still exists.
> Not sure where that's coming from.  Any ideas?  Just leave it?

Just leave it. IIRC pan0 is related to bluetooth.

-- 
Fajar


>
> On Wed, Feb 23, 2011 at 7:42 AM, Fajar A. Nugraha <list@xxxxxxxxx> wrote:
>>
>> On Wed, Feb 23, 2011 at 8:38 PM, Ted Brenner <griztown@xxxxxxxxx> wrote:
>> > Thanks Fajar and Pasi,
>> >
>> > I'm not sure how to add my IP to the bridge.  It tells me 10.0.0.3 is
>> > not an
>> > interface.  I'm sorry if I don't know much about networking.
>> >
>> > Here's my /etc/network/interface
>> >
>> > # more /etc/network/interfaces
>> > # This file describes the network interfaces available on your system
>> > # and how to activate them. For more information, see interfaces(5).
>> >
>> > # The loopback network interface
>> > auto lo
>> > iface lo inet loopback
>> >
>> > # The primary network interface
>> > allow-hotplug eth0
>> > #NetworkManager#iface eth0 inet dhcp
>>
>> That's it? No mention about br0 whatsoever on /etc/network/interfaces?
>>
>> Then start by following the example /etc/network/interfaces on the
>> debian wiki. It should be clear enough. You HAVE, read the wiki page,
>> right?
>>
>> --
>> Fajar
>
>
>
> --
> Ted Brenner
>

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users