Re: [Xen-users] How to use "xe tunnel-create" to create GRE tunnel?

[frank <frank@xxxxxxxxx>]

 What "controller" means here? is it an openflow controller or 
controller made by xensource?
as I know, openflow standard has no definition for creating a GRE tunnel.
thank you

On 12/12/2010 08:11 AM, Rob Hoes wrote:
> Hi Frank,
>
> You need to connect the Open vSwitch Controller that came with XS 5.6 FP1 beta 
> to your pool. The controller sees the tunnels that you create by the xe 
> commands (as you did), and will create the GRE ports on the vSwitches for you.
>
> Regards,
> Rob
>
> On 11 Dec 2010, at 01:47, frank wrote:
>
> >   Hi,
> >      In XenServer5.6 FP1 beta, I have switched default bridge to open
> > vswitch, I wonder how to use "xe tunnel-create" to create a GRE tunnel.
> >
> > my commands:
> >
> > xe tunnel-create pif-uuid=eth0_uuid
> > network-uuid=network_created_by_xe_network_create
> >
> > then I got an uuid which is "access-PIF" of output from "xe tunnel-list".
> >
> > what should I do next? how to set remote_ip and GRE type and GRE key?
> >
> > I already know how to do these by open vswitch, I just want to use xe
> > command do same things.
> >
> > than kyou.
> >
> > --
> > Frank Zhang
> > Cloud.com INC
> >
> >
> > _______________________________________________
> > Xen-users mailing list
> > Xen-users@xxxxxxxxxxxxxxxxxxx
> > http://lists.xensource.com/xen-users

--
Frank Zhang
Cloud.com INC


_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users