RE: Re: [Xen-users] DomU doesn't boot after adding the vif.

[나제균 <archdoom@xxxxxxxxx>]

Some other blogs and sites also say that just input the IP address.

 

Therefore, I trusted that wiki and have no doubt.

 

Actually, the reason for using NAT is that I want to run the xorp (virtrual router software) on the domU and dom0.

 

When I used the virbr0 and xenbr0, the routing protocol runned by xorp did not find each other.

 

I tcpdumped all the interface on dom0, and thought that the bridge network did somethig strange.

 

Also, the vifX.0 dose not send or receive any of the packets and acts like a dummy.

 

So I configured the NAT mode and want the following situation.

 

----------------------------      --------------

|  eth0 ----- vif1.0 ---|------|---eth0   |

----------------------------      --------------

      dom0+xorp           dom1+xorp

 

As you mentioned, I inserted the static MAC address to the 'vif =[ ]' after the IP address.

 

However, it still does not show the POST screen.

 

PS) The xen on CentOS is a default package.

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users