Re: [Xen-users] can't add vlans successfully

[Zhang Li <cindy.zhangli@xxxxxxxxx>]

On Tue, Aug 11, 2009 at 12:46 PM, Fajar A. Nugraha<fajar@xxxxxxxxx> wrote:
> On Tue, Aug 11, 2009 at 10:56 AM, Zhang Li<cindy.zhangli@xxxxxxxxx> wrote:
>> Then we use brctl show, we can see eth0.100 and eth0.101 bridges is
>> start up.  Then we start 4 xenU, 2 xenUs on each bridges.
>
> Can you paste the output of brctl show? I doubt the built-in
> network-bridge works for vlan interfaces as it involves some interface
> renaming (e.g. eth0 -> peth0).
>

The brctl show output:

bridge name     bridge id               STP enabled     interfaces
eth0.100                8000.0024e827dae4       no              peth0.100

           vif1.0

           vif2.0
eth0.101                8000.0024e827dae4       no              peth0.101

           vif3.0

           vif4.0
eth0            8000.0024e827dae4       no              peth0


>>
>> But questions is that: I can't get the 8021q packages with ethereal
>> tool.
>
> Which interface did you run ethereal on?
>

    I run ethereal on eth0.

>>  I doubt that I don't setup the vlans successfully. And xenU in
>> the vlans can't connect the outside by using ping address.
>
> For starters, for complex configurations like this I find it easier to
> simply use the OS configuration scripts to setup bridge/vlans (on
> redhat this would be /etc/sysconfig/network-scripts/ifcfg-*) and
> comment-out nwtroking scripts on /etc/xen/xend-config.sxp.
>
> After that, I'd test whether vlan works before throwing in bridge and
> Xen to mix. For example, I'd create eth0.100 on top of eth0, and test
> it. If it works, I create br100 on top of eth0.100 and move the IP
> address to br100. After it works, I tell domU to use br100 as bridge.
>

   Thanks for your suggestion, I will have a try.
> --
> Fajar
>



-- 
Best regards
--Li

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users