Re: [Xen-users] vif-route script not getting domU-IP (vif-IP)

[Ray Barnes <tical.net@xxxxxxxxx>]

I'm using individual vif-route scripts for each domU for customization reasons.  But in your case, the most likely culprit is that you have no "ip=" in the vif statement in the domU config file.

 

-Ray

 

On Tue, Jun 23, 2009 at 9:51 AM, Maik Brauer <mailinglist@xxxxxxxxxxxxxxx> wrote:

Hi,

I'm using the XEN 3.4.1-pre4 Hypervisor in Routet Mode and I'm facing some problems when I start the DomU.
In detail, it means that the DomU IP-Adress will not be implemented in the Kernel routing table after starting the domU via "xm create /<path+configfle>"
After making a "netstat -nr" it will not show the IPadress bound to the VIF<..>-interface.

A small echo in the vif-route script shows that the variable $IP is empty. So no value will be available, therefore the script can't work.

if [ "${ip}" ] ; then
   # If we've been given a list of IP addresses, then add routes from dom0 to
   # the guest using those addresses.
   for addr in ${ip} ; do
     ${cmdprefix} ip route ${ipcmd} ${addr} dev ${vif} src ${main_ip}
   done
fi

Has sombody faced the same problems ?

Cheers,
Maik

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users