[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: [Xen-users] Simple question about Para-virtualized drivers in Windows
Thanks a lot again for your reply. > tap:aio should be for file-backed images, not devices. You should have > disk = [ "tap:aio:/PathToMyImage.img,hda,w", "phy:/dev/sda1,xvdb,w" ] I followed this procedure, where says that tap:aio should be used (isn't it rigth?): http://www.redhat.com/docs/en-US/Red_Hat_Enterprise_Linux/5.2/html/Para-Virtualized_Windows_Drivers/sect-Para-Virtualized_Windows_Drivers-Installing_and_configuring_the_para_virtualized_drivers-Post_installation_host_configuration.html >How many disks you have each? Do you have one or two QEMU disks? >QEMU harddisk should be hda, while RHEL disk should be xvdb. With this configuration I saw three devices: disk = [ "file:PathToMyImage.img,hda,w", "tap:aio:/dev/sda1,xvdb,w" ] The devices are: 1) "c:" (10GB) 2) "QEMU HARDDISK" (50GB) 3) "RHEL DISK SCSI Disk Device" (50GB) The only difference between 2) and 3) are in their Properties: 2) says "Location: Location 1 (1)" 3) says "Location: Bus Number 0, Target Id 0, LUN 1" So I'm not sure if I should put my data in 2) or 3). Thanks for your time. Regards. On Tue, May 19, 2009 at 10:36 PM, Fajar A. Nugraha <fajar@xxxxxxxxx> wrote:
_______________________________________________ Xen-users mailing list Xen-users@xxxxxxxxxxxxxxxxxxx http://lists.xensource.com/xen-users
|
Lists.xenproject.org is hosted with RackSpace, monitoring our |