Re: [Xen-users] bridge to route mode

[HU wenjin <wenjin.hu@xxxxxxxxx>]

You probably miss  (vif-script vif-route)  in your Xend configuration file.

Also, to configure Xen guest configuration file in routing mode is a little tricky. Make sure you have specify the gateway as your dom0's IP correct and also specify the same IP in your running guest as in your guest configuration file.

Good luck!

~wenjin

On Fri, May 1, 2009 at 12:42 PM, Siddharth Wagh <siddharth.wagh@xxxxxxxxx> wrote:

I made the necessary changes in xend-config.sxp, network-route and guest config files to switch over to routing mode (as suggested in "Running Xen" book). I created guest VMs and I restarted xend. But when I checked ifconfig, but it still shows me the bridge configuration. Can anyone tell me what I am missing here??

Thanks & Regards,
Siddharth Wagh
MS, Electrical & Computer Engineering
Rutgers University, NJ
Web: http://www.eden.rutgers.edu/~swagh/

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users