[Xen-users] compiling Xen 3.3.1 on Lenny

[Peter <vmail@xxxxxxxxxxxxx>]

Hi
I was wondering what is the official procedure to compile Xen 3.3.1. In 
fact the readme that comes with this release says:
make world
make install

however, this does not copy the compiled vmlinuz-2.6.26-1-xen-686   into 
/boot
it seems that I have to run

./install.sh

as well.

if instead I say:

make world KERNELS="linux-2.6-xen0 linux-2.6.-xenU"

as suggested in the readme and in the users manual, I will get:

vmlinuz-2.6.18.8-xen0 and vmlinuz-2.6.18.8-xenU  
( note the different versions )
also , the xen download site talks about 2.6.18.-8 and not ( yet ) about 
2.6.26.1
in a recent mail , the following procedure was suggested:
> Hi:
> Please refer to http://www.xen.org/download/docs/xen33.linux-2.6.18.README.txt.
>
> steps:
> 1. download the xen-3.3.1.tar.gz
> 2. tar -zxf xen-3.3.1.tar.gz
> 3. Download kernel code by 
> "http://www.xen.org/download/docs/xen33.linux-2.6.18.README.txt";
> 4. cd to folder xen-3.3.1
> 5. make prep-kernels.
> 6. run other make commands you want.( you can get help by "make help")
>
>
> enjoy your time :)
>
> Shunli
>   
My questions are:
on a fresh debian lenny system:
1) what is the recommend installation command sequence ?
2) what is the recommend kernel version for dom0 and domU ?

Thanks very much for your help
peter


_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users