[Xen-users] trouble setting up external IP

[Charlie Reddington <charlie.reddington@xxxxxxxxx>]

Hey Everyone,

I've never run into this problem before so I'm not exactly sure where  
to start.
If I leave the dhcp settings alone, and let the new guest VM take the  
settings, I can successfully ping outside and connect past the dom0.
But when I try to setup the interface to use external settings, I can  
not ping outside. I can ping the local host (guest vm), I can ping the  
gateway. But I can't go out from there.
I have a few external IP's that I knew for a fact where working, as I  
shut down a box to setup this box. So I'm not sure if this is perhaps  
an issue with the comcast router / modem that I have, or with settings  
I have in place on the guest vm / dom0.
I've done this before, and I tried comparing my setups and they seem  
to be the same.
Any suggestions on where / how to start looking here would be greatly  
appreciated.
Charlie


_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users