[Xen-users] Problems with PCI Passthrough on PVM

["Ralf Hornik Mailings" <ralf@xxxxxxxxxxxxxxxxx>]

Hi list,

I try to pass a Promise Ultra133 TX2 to a PVM.

On the PVM I can see the controller using lspci

"06:00.0 Mass storage controller: Promise Technology, Inc. 20269 (rev 02)"

But I cannot access /dev/hdaX because dmesg shows

"ide: Assuming 66MHz system bus speed for PIO modes
PDC20269: IDE controller at PCI slot 0000:06:00.0
PCI: Enabling device 0000:06:00.0 (0000 -> 0003)
PDC20269: chipset revision 2
PDC20269: ROM enabled at 0xffffc000
PDC20269: 100% native mode on irq 20
    ide0: BM-DMA at 0x1000-0x1007, BIOS settings: hda:pio, hdb:pio
    ide1: BM-DMA at 0x1008-0x100f, BIOS settings: hdc:pio, hdd:pio
Probing IDE interface ide0...
hda: SAMSUNG HD300LD, ATA DISK drive
PM: Adding info for No Bus:ide0
ide0: Disabled unable to get IRQ 20.
ide0: failed to initialize IDE interface
Probing IDE interface ide1...
pnp: the driver 'ide' has been registered
pnp: the driver 'i8042 kbd' has been registered
pnp: the driver 'i8042 aux' has been registered
pnp: the driver 'i8042 kbd' has been unregistered
pnp: the driver 'i8042 aux' has been unregistered"

My dom0 has no problems accessing this device, and the domU boots the  
same kernel and initrd.
The Kernel version is the latest stable from xen.

Can somebody tell me whats wrong?

Thank you and best regards


Ralf


_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users