Re: [Xen-users] cross hypervisor communication problem

["Andy Burns" <xen.lists@xxxxxxxxxxx>]

2008/8/20 Eric Ross <eross@xxxxxxx>:

> Dom0 brctl output
>
> bridge name     bridge id               STP enabled     interfaces
> xenbr0          8000.feffffffffff       no              vif0.0
>                                                        peth0
> xenbr1          8000.feffffffffff       no              vif0.1
>                                                        peth1
> NOTE: this is the same for all my Dom0s

Are the ports of the switches that your dom0s are connected to set to
"portfast" mode? (ok that's a cisco term but other brands have their
equivalent)  they should *not* be.

If using Cisco, other portsecurity settings can clash such as only
allowing single MAC addresses per port etc.

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users