Re: [Xen-users] vlans+bonding+bridging

[Longina Przybyszewska <longina@xxxxxxxxxxxx>]

Thanks for immediate help !:-)

Yes, it is Cisco switch - I have not access to it - have to ask network 
people to check configuration.
I have got another basic problem:
this is PE2950 with 6 NICs, but I would like to bind together 2 Broadcom 
cards  eth4+eth5--->bond0.
1. they are bound together in a way - because I can set up IP address only 
for one card. If both cards get IP I'm loosing networking.
2. if I try to run (only eth5 is configured on boot)
mii-tools -v
I get :
SIOCGMIIPHY on 'eth4' failed: Resource temporarily unavailable
SIOCGMIIPHY on 'eth5' failed: Operation not supported

Both cards are on the same switch, only eth5 is configured on boot
(/etc/networking/interfaces - as I run Ubuntu Hardy)

Could it be TOE issue (TCP/IP offload engine jumper set op in BIOS)?

Thanks in advance
longina

On Wed, 16 Jul 2008, Martin Hierling wrote:

> Hi,
>
> > > I would like to enslave 2 NICs via bond interface.
> > > Both NICs are on trunk ports which are configured in the same way, the
> > > same native vlan.
> > Sounds like Cisco ;)
> if it is so you have to configure static portchannel on cisco site.
>
> Martin
>
> _______________________________________________
> Xen-users mailing list
> Xen-users@xxxxxxxxxxxxxxxxxxx
> http://lists.xensource.com/xen-users
--
--
Longina Przybyszewska, system programmer
IT@Naturvidenskab

IMADA, Department of Mathematics and Computer Science

University of Southern Denmark, Odense
Campusvej 55,DK-5230 Odense M, Denmark

tel: +45 6550 2359 - http://www.imada.sdu.dk
email: longina@xxxxxxxxxxxx
--

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users