[Xen-users] Re: reload nic modules after boot

["Marco Strullato" <marco.strullato@xxxxxxxxx>]

I add this log from /var/log/messages

Jun 25 09:32:05 hyp02 kernel: bnx2: eth0 NIC Copper Link is Up, 100
Mbps full duplex, receive & transmit flow control ON
Jun 25 09:32:05 hyp02 kernel: NET: Registered protocol family 10
Jun 25 09:32:05 hyp02 kernel: lo: Disabled Privacy Extensions
Jun 25 09:32:05 hyp02 kernel: IPv6 over IPv4 tunneling driver
Jun 25 09:32:05 hyp02 kernel: Bridge firewalling registered
Jun 25 09:32:05 hyp02 kernel: tmpbridge: Dropping NETIF_F_UFO since no
NETIF_F_HW_CSUM feature.
Jun 25 09:32:05 hyp02 kernel: ADDRCONF(NETDEV_UP): peth0: link is not ready
Jun 25 09:32:06 hyp02 kernel: bnx2: peth0 NIC Copper Link is Up, 100
Mbps full duplex, receive & transmit flow control ON
Jun 25 09:32:06 hyp02 kernel: ADDRCONF(NETDEV_CHANGE): peth0: link becomes ready
Jun 25 09:32:06 hyp02 kernel: device peth0 entered promiscuous mode
Jun 25 09:32:06 hyp02 kernel: audit(1214379126.926:2): dev=peth0
prom=256 old_prom=0 auid=4294967295 ses=4294967295
Jun 25 09:32:07 hyp02 kernel: tmpbridge: Dropping NETIF_F_UFO since no
NETIF_F_HW_CSUM feature.
Jun 25 09:32:07 hyp02 kernel: ADDRCONF(NETDEV_UP): peth1: link is not ready
Jun 25 09:32:07 hyp02 kernel: device peth1 entered promiscuous mode

2008/6/25 Marco Strullato <marco.strullato@xxxxxxxxx>:
> Hi all, it's happening a strange thing:
>
> After I boot the xen dom0 network is unavailable: I have to unload the
> network modules and load it again ( rmmod / modprobe) and execute a
> service network restart)
>
> This is strange, what do you suggest me to check?
>
> Thanks
>
>
> Marco Strullato
>

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users