[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Xen-users] Xenbr0 doesn't talk to outside
- To: "you_bear zhou" <youbear.zhou@xxxxxxxxx>
- From: "Ray Barnes" <tical.net@xxxxxxxxx>
- Date: Tue, 17 Jun 2008 16:54:32 -0400
- Cc: xen-users@xxxxxxxxxxxxxxxxxxx
- Delivery-date: Tue, 17 Jun 2008 13:55:03 -0700
- Domainkey-signature: a=rsa-sha1; c=nofws; d=gmail.com; s=gamma; h=message-id:date:from:to:subject:cc:in-reply-to:mime-version :content-type:references; b=QSK33S9Sxr6Ng4jQmKEFy8qoA9uXUq0u42jJrGbf1PEoApxI3JLQbuYsJYKa8Luu6K +rdWKCSFwKQWH1U4nPDFY+Av9cTp/b9QRXInb1hjSQqRHcHkcd2qmIz39sMyCjRBu2yz OSCknSJixlTAf6Md7Ufjby+2y5YQqdXLdjFz0=
- List-id: Xen user discussion <xen-users.lists.xensource.com>
I'm no expert on bridged networking under Xen (I only use routed networking in production), but start by making sure "bridge=xenbr0" is in your domU vif config file (make sure you have a vif setup too....), and check the dom0 to make sure the bridge is bridging your domU to the physical NIC using "brctl show".
-Ray
On Tue, Jun 17, 2008 at 10:11 AM, you_bear zhou < youbear.zhou@xxxxxxxxx> wrote:
Hi, all,
I installed xen 3.0.3 on Ubuntu 7.10, and I set up VM dapper using xen-tools. Now, my VM can be boot successfully but without network.
I used wireshark and tcpdump to trace, I found that the vm sent requests to xenbr0, but xenbr0 didn't send them out ! In dom0, I can't see any request from domU.
In xend.conf, I use network-bridge and vif-bridge as default.
Maybe this problem is very simple, but as a beginner, it puzzled me a lot!
I do appreciate if someone can help me out. !
Best,
--
Fangfei Zhou
----------------------------------------------------
I have a dream, fly to the sky
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users
|
