Re: Fwd: [Xen-users] Unable to create more than 1 VM

[Thomas <iamkenzo@xxxxxxxxx>]

Ok, now I am able to add the mac address and have expected behavior in
the Dom0 and DomU ifconfig output using:
vif = [ 'mac=00:16:3e:00:00:01, ip=10.0.0.1' ]

with the proper gateway and netmask, the network is back in business
using NAT and is reachable from anywhere on the planet.

I still have the problem of booting a second VM. The problem is I
can't post any output from the boot message as I always get the
following error message after issuing:
-----
# xm create -c node02
------
xenconsole: Could not read tty from store: No such file or directory
------
However I do see a new vif with IP 10.0.0.129 in Dom0, that's what you
were talking about previously.


That's all I have beside the log file I have posted earlier which is
still the same:
------
xs_read(): vncpasswd get error.
/vm/365db4c4-4efc-54dc-2b01-19287a470079/vncpasswd.
bind() failed


Gasp, I was almost there... I am sure it is some stupid configuration
value to adjust that is messing everything up like this, and the
documentation is so scarce...

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users