Re: [Xen-users] Host uses one NIC; Guest OS uses other NIC

[James Pifer <jep@xxxxxxxxxxxxxxxx>]

On Tue, 2008-04-01 at 02:41 +0300, Igor Chubin wrote:
> On Mo, MÃr 31, 2008 at 12:49:33 -0400, James Pifer wrote:
> > I'm trying to setup my first Xen server that will host two Virtual
> > Servers. I have the first guest OS installed, but I cannot get it to
> > connect to the network. 
> 
> 
> Please, show the output of
> 
> # brctl show
> 
> run in dom0
> 
> and provide more info about procedure you use
> to test network connectivity.
> 
> 

xen01:~ # brctl show
bridge name     bridge id               STP enabled     interfaces
xenbr1          8000.feffffffffff       no              vif3.0



As far as testing I have no connectivity on the guest OS (Suse 10.1).
Firewall is turned off. iptables -L gives:
# iptables -L
Chain INPUT (policy ACCEPT)
target     prot opt source               destination         

Chain FORWARD (policy ACCEPT)
target     prot opt source               destination         

Chain OUTPUT (policy ACCEPT)
target     prot opt source               destination 


On dom0 iptables -L shows:
iptables -L
Chain INPUT (policy ACCEPT)
target     prot opt source               destination         

Chain FORWARD (policy ACCEPT)
target     prot opt source               destination         
ACCEPT     all  --  anywhere             anywhere            PHYSDEV match 
--physdev-in vif3.0 

Chain OUTPUT (policy ACCEPT)
target     prot opt source               destination         



As far as testing, I can't ping, I can't ssh, I can't do anything to or
from the statically assigned address that I've assigned the host. 

The IP address is not being used
The subnet is correct
The default gateway is set (although I can't even get to things on the
same subnet anyway)

What other information can I provide? Or, any suggestions?

Thanks,
James


_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users