RE: [Xen-users] Re: Unable to load eth0 and start xend--Using Xen 3.2.0on an FC8

["Tait Clarridge" <Tait.Clarridge@xxxxxxxxxxxx>]

I don’t think you are trying to load the right module. Check your standard kernel and see what NIC module it is loading… probably something along the lines of bcm5700 or something like that. Make sure your xen kernel has that as a module and try again (after changing modprobe.conf obviously).

 

Cheers,

Tait

 

From: xen-users-bounces@xxxxxxxxxxxxxxxxxxx [mailto:xen-users-bounces@xxxxxxxxxxxxxxxxxxx] On Behalf Of Argyro Andreou
Sent: Thursday, February 21, 2008 3:15 PM
To: xen-users@xxxxxxxxxxxxxxxxxxx
Subject: [Xen-users] Re: Unable to load eth0 and start xend--Using Xen 3.2.0on an FC8

 

Also I just wanted to give you the type of my eth card if that would help:

 

Broadcom NetXtreme 57xx Gigabit Controller

 

Please help !!!!!

 

Thanks

Argyro

On Thu, Feb 21, 2008 at 1:15 PM, Argyro Andreou <argyro.andreou@xxxxxxxxx> wrote:

Hi all,

 

Sorry for starting up a new thread on this issue..email mixups :P

 

Anyway...I'm running Xen 3.2.0 on an FC8 system. I compiled Xen from the source code. The xen kernel is loading fine with the exception that when I try to start xend it says that device eth0 does not exist.

 

ifconfig -a results only in showing the loopback interface

modprobe e1000 and then ifconfig -a results in showing the sit0 interface in addition to the loopback interface.

 

ifconfig eth0 up results in an error saying that eth0 does not exist.

lsmod -a shows that e1000 is loaded

 

Also in the modprobe.conf file I have alias eth0 e1000

 

Any ideas what's happening ? Why it doesn't detect the eth0 interface?

 

Thanks in advance

Argyro

 

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users