Re: [Xen-users] two bridges with xen 3.2.0

[Sadique Puthen <sputhenp@xxxxxxxxxx>]

Jordi Moles wrote:
> hi,
>
> i'm trying the new 3.2.0.
In 3.2 the bridge names are replaced as eth0 and eth1 instead of xenbr0 
and xenbr1. So you have to change your scripts accordingly
--Sadique

> i've always used two bridges since 3.0.x with the following set up:
>
> Replace
>
> (network-script network-bridge)
>
> with
>
> (network-script network-bridge-both)
>
> in file /etc/xen/xend-config.sxp
>
> The content of network-bridge-both is
>
> ************
>
> #!/bin/sh
> dir=$(dirname "$0")
> "$dir/network-bridge" "$@" vifnum=0 netdev=eth0 bridge=xenbr0
> "$dir/network-bridge" "$@" vifnum=1 netdev=eth1 bridge=xenbr1
>
> ************
>
> As i said, this used to work for 3.0.x and 3.1.x releases.....
>
> Now, it doesn't work anymore...
>
> when the xen loads....
>
> there's only this in the ifconfig command:
>
> -lo
> -peth0
> -peth1
>
> What's different from the earlier releases? Thank you.
>
> _______________________________________________
> Xen-users mailing list
> Xen-users@xxxxxxxxxxxxxxxxxxx
> http://lists.xensource.com/xen-users

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users