[Xen-users] Bridging under XEN 3.0.4

[Wayne Mallett <wayne.mallett@xxxxxxxxxx>]

G'day all,

I am having a problem with XEN 3.0.4.  Occasionally, when I have to  
reboot a VM with multiple NICs, the network devices appear to swap -  
i.e., eth0 now appears to be going through xenbr1 and eth1 now  
appears to be going through xenbr0  whereas earlier eth0 and xenbr0  
were aligned and so were eth1 and xenbr1.  I have temporarily fixed  
it by swapping the ifcfg-eth0 and ifcfg-eth1 files and restarting the  
network on the VMs however I would like to fix it properly.  Any  
ideas on how I might go about doing this?
Note:  Looking at the logs the correct MAC addresses (for the VM) are  
being assigned to the interfaces on the correct bridges.  The results  
however indicate that something else happened.
Regards,

Wayne Mallett

Dr. Wayne Mallett
High Perf. & Research Computing Support
Information Technology & Resources
James Cook University
Townsville  Qld  4811
Australia

Ph (int):  5084
Ph (ext) :  07 4781 5084
Email:  Wayne.Mallett@xxxxxxxxxx




_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users