I had some problems with this as well when
I had Xen installed via the RPM’s. My solution was to uninstall Xen via the RPM’s and
install via source instead, making sure to enable anything that had to do with
NAT.
I’ve since been told that I could
have just enabled a few modules, but I have yet to test that theory out.
Here’s a walkthrough describing what
I did however. The main thing is that
you want to enable NAT as your networking scripts. I’ve installed 3 Xen
systems, and 2 of them were setup using this walkthrough that I made, so it
should work for you.
http://mitopia.net/index.php/Xen_3.0.2_Setup
Mito
From:
xen-users-bounces@xxxxxxxxxxxxxxxxxxx
[mailto:xen-users-bounces@xxxxxxxxxxxxxxxxxxx] On Behalf Of bruno taranto
Sent: Tuesday, June 20, 2006 10:38
AM
To: Xen-users@xxxxxxxxxxxxxxxxxxx
Subject: [Xen-users] dom0 as
router
Hy,
I am tryin to configure my dom0 as router of my domU, but dont work.
Can you give me some help?
DOM0---------------
dcgs0058:/etc/xen# ifconfig |grep net
dummy0 Link encap:Ethernet HWaddr 9E:B7:78:DB:E9:A7
inet addr:192.168.0.1 Bcast:192.168.0.255 Mask:255.255.255.0
eth0 Link encap:Ethernet HWaddr
00:13:72:4E:7E:B3
inet addr:172.28.0.200 Bcast:172.28.0.255 Mask:255.255.255.0
peth0 Link encap:Ethernet HWaddr
FE:FF:FF:FF:FF:FF
vif0.0 Link encap:Ethernet HWaddr FE:FF:FF:FF:FF:FF
vif1.0 Link encap:Ethernet HWaddr FE:FF:FF:FF:FF:FF
xenbr0 Link encap:Ethernet HWaddr FE:FF:FF:FF:FF:FF
DOMU---------------
debian:~# ifconfig |grep net
eth0 Link encap:Ethernet HWaddr
00:16:3E:3A:84:0E
inet addr:192.168.0.2 Bcast:192.168.0.255 Mask: 255.255.255.0
debian:~# route -n
Kernel IP routing table
Destination
Gateway
Genmask Flags Metric
Ref Use Iface
192.168.0.0 0.0.0.0
255.255.255.0
U 0
0 0 eth0
0.0.0.0
192.168.0.1 0.0.0.0
UG 0
0 0 eth0
debian:~#
bruno taranto
