[Xen-users] Re: Network setup in para guest

[Matthew Palmer <mpalmer@xxxxxxxxxxx>]

On Tue, May 16, 2006 at 12:38:21AM +0000, pak333@xxxxxxxxxxx wrote:
> I have launched a para guest in xen and when I try and ping the dom0 eth0 IP 
> address; i get : network unreacheable
> 
> In dom0: a "brctl show" shows 
> 
> bridge name     bridge id               STP enabled     interfaces
> xenbr0          8000.000e0c4282f4       yes              vif0.0
>                                                                               
> peth0
>                                                                              
> eth0
>                                                                            
> vif1.0
> 
> an ifconfig in the guest shows just eth0.
> eth0      Link encap:Ethernet  HWaddr AA:00:00:00:00:11
>           UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
>           RX packets:0 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
>           collisions:0 txqueuelen:1000
>           RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)
> 
> There is no log in dmesg/xm dmesg.
> Am I missing some steps 

Yes, you're not giving the guest an IP address.  DHCP or static assignment
in the guest's network config is recommended.

- Matt

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users