Re: [Xen-users] Cannot have eth0 in domU

["Fong Vang" <sudoyang@xxxxxxxxx>]

Thank you!  Thank you!  Thank you!

I have the exact same problem on FC5 (didn't have this on FC4).  I've
been searching for a solution for the past 1.5 days.  In FC4 it was
automatic so I didn't expect to have to load the module manually. 
Loading xennet enables the interface.  It's aliiiive!!


On 4/5/06, Christian Horn <chorn@xxxxxxxxxxxx> wrote:
> On Sat, Mar 25, 2006 at 12:10:04PM -0500, cqfd wrote:
> > I am trying to run Xen 3 on FC5, but I cannot have the eth0 interface 
> > appear in domU.
>
> >   kernel = "/boot/vmlinuz-2.6.15-1.2054_FC5xenU.img"
> Fedora drops the file /boot/vmlinuz-2.6.15-1.2054_FC5xenU here, but maybe
> you renamed the file.
>
> > - everything in domU is fine except that eth0 is not seen:
> >   ifconfig eth0
> >   eth0: error fetching interface information: Device not found
> Tried to load module xennet?
>
>
> _______________________________________________
> Xen-users mailing list
> Xen-users@xxxxxxxxxxxxxxxxxxx
> http://lists.xensource.com/xen-users
>

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users