[Xen-users] Re: multiple ips for veth?

[Roger Keays <roger.keays@xxxxxxxxxxxxxxxxxx>]

Some output from the dom0 if its of any use:


[root@harrie xen]# brctl show
bridge name     bridge id               STP enabled     interfaces
xenbr0          8000.feffffffffff       no              peth0
                                                        vif0.0
                                                        vif2.0
                                                        vif2.1

[root@harrie xen]# ip ro
10.252.9.0/24 dev eth0  proto kernel  scope link  src 10.252.9.11
10.252.9.0/24 dev eth0  proto zebra  metric 10 equalize
169.254.0.0/16 dev eth0  scope link
default via 10.252.9.1 dev eth0

[root@harrie xen]# arp -na
? (10.252.9.1) at 00:04:96:20:AB:2A [ether] on eth0
? (10.252.9.12) at 00:16:3E:5F:26:4C [ether] on eth0


Roger Keays wrote:
> Hi,
>
> Is it possible to configure a domU with multiple IP addresses?
>
> i.e. (v)eth0 and (v)eth0:0, or (v)eth0 and lo:0
>
> I can add the additional interface in the domU just fine so that it 
> shows up in ifconfig, but the bridge doesn't seem to do its magic to 
> make it accessible.
> vif = [ 'bridge=xenbr0', 'bridge=xenbr0' ]
>
> The docs tend to indicate that vifx.1 will always go to (v)eth1, but 
> unfortunately I can't get the bridge to do (v)eth1 either :(
> Thanks in advance,
>
> Roger

--
----------------------------------------
Ninth Avenue Software
p: +61 7 3870 8494 (UTC +10)
f: +61 7 3870 8491
w: http://www.ninthavenue.com.au
e: info@xxxxxxxxxxxxxxxxxx
----------------------------------------


_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users