Hi, I’m working with Xen 3.0.1 and I have the
following problem:
I’m running Xen in a VT enabled Intel processor, I
have successful installed a Fedora Core 4 32 bits Guest using VT. But the
Network interface doesn’t appear in the Guest. I mean,
running the commands “ifconfig –a” doesn’t show any
eth0 interface just lo.
In the /sys/class/net directory there is not any ethX
interface and neither in the dmesg log appears nothing about eth0.
Finally when I run the command: lspci –v, there are
the following devices:
Host bridge: Intel Corporation 440FX
ISA bridge: Intel Corporation 82371SB
IDE interface: Intel Corporation 82371SB
VGA compatible controller: Cirrus Logic GD
And anything about a Network interface.
What can I do?, running a Linux Paravirtualized Guest (xenU)
shows the interface eth0 without any problem. I adjusted the .config file for
the xen0 domain. I added EHCI support and USB mass storage, and also support
for SMP machines.
I did it using the following command:
In the xen directory:
make linux-2.6-xen0-config CONFIGMODE=menuconfig
make linux-2.6-xen0-build
make linux-2.6-xen0-install
And reboot.
What options are needed in the .config file for Xen0 in
order to create the virtual network devices in the VMX guests?
Thanks
Jesús
