Re: [Xen-users] only one NIC supported?

[David Koski <david@xxxxxxxxxxxxxxxx>]

On Thursday 02 February 2006 11:31 pm, Rowan Woodhouse wrote:
> Hi,
> 
> try:
> 
> # ./network-bridge start bridge=xenbr1 netdev=eth1 vifnum=1
> 
> which will cause xen to use veth1 rather than veth0 which is probably 
> being used for xenbr0.

That did it, thanks!

But it used to work without a custom script. Is there a way to
configure xend-config.sxp so a custom script is not needed?

Regards,
David



_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users