[Xen-users] Setting up FSTAB

["Randolph D. Hill" <rdh@xxxxxxxxxxxxxxxx>]

I am setting up Xen for the first time and have run into a problem.
My system was initially setup with Fedora Core 4.
I was able to successfully create a File-backed VBD.
When I boot the domain,I get an error message that is listed at the end of
the below boot messages. I suspect the problem is casued by my fstab.
However,
I am not sure how it should be configured. Fstab listed also.
Any pointers will be greately appreciated.

xm create -c dommain2 vmid=2
Using config file "/etc/xen/dommain2".
Started domain TheArtOfXen2
Linux version 2.6.12.6-xen3_7.1_fc4 (rread@shandlx) (gcc version 4.0.1
20050727 (Red Hat 4.0.1-5)) #1 SMP Tue Dec 13 16:33:43 PST 2005
BIOS-provided physical RAM map:
Xen: 0000000000000000 - 0000000004000000 (usable)
0MB HIGHMEM available.
72MB LOWMEM available.
ACPI in unprivileged domain disabled
IRQ lockup detection disabled
Built 1 zonelists
Kernel command line:  ip=:1.2.3.4::::eth0:dhcp root=/dev/hda1 ro 4
Initializing CPU#0
PID hash table entries: 512 (order: 9, 8192 bytes)
Xen reported: 993.322 MHz processor.
Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
Software IO TLB disabled
vmalloc area: c5000000-fb7fe000, maxmem 34000000
Memory: 60684k/73728k available (2214k kernel code, 4708k reserved, 885k
data, 188k init, 0k highmem)
Checking if this processor honours the WP bit even in supervisor mode... Ok.
Security Framework v1.0.0 initialized
SELinux:  Disabled at boot.
Capability LSM initialized
Mount-cache hash table entries: 512
CPU: L1 I cache: 16K, L1 D cache: 16K
CPU: L2 cache: 256K
Enabling fast FPU save and restore... done.
Enabling unmasked SIMD FPU exception support... done.
Checking 'hlt' instruction... disabled
Brought up 1 CPUs
NET: Registered protocol family 16
Brought up 1 CPUs
ACPI: Subsystem revision 20050309
ACPI: Interpreter disabled.
Linux Plug and Play Support v0.97 (c) Adam Belay
xen_mem: Initialising balloon driver.
usbcore: registered new driver usbfs
usbcore: registered new driver hub
PCI: Using ACPI for IRQ routing
PCI: If a device doesn't work, try "pci=routeirq".  If it helps, post a
report
PCI: System does not support PCI
PCI: System does not support PCI
Grant table initialized
IA-32 Microcode Update Driver: v1.14-xen <tigran@xxxxxxxxxxx>
VFS: Disk quotas dquot_6.5.1
Dquot-cache hash table entries: 1024 (order 0, 4096 bytes)
Initializing Cryptographic API
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
PNP: No PS/2 controller found. Probing ports directly.
i8042.c: No controller found.
io scheduler noop registered
io scheduler anticipatory registered
io scheduler deadline registered
io scheduler cfq registered
RAMDISK driver initialized: 16 RAM disks of 16384K size 1024 blocksize
Xen virtual console successfully installed as tty1
Event-channel device installed.
netfront: Initialising virtual ethernet driver.
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx
Registering block device major 8
ide-floppy driver 0.99.newide
mice: PS/2 mouse device common for all mice
NET: Registered protocol family 2
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP established hash table entries: 4096 (order: 3, 32768 bytes)
TCP bind hash table entries: 4096 (order: 3, 32768 bytes)
TCP: Hash tables configured (established 4096 bind 4096)
NET: Registered protocol family 8
NET: Registered protocol family 20
VFS: Cannot open root device "hda1" or unknown-block(0,0)
Please append a correct "root=" boot option
Kernel panic - not syncing: VFS: Unable to mount root fs on
unknown-block(0,0)


# This file is edited by fstab-sync - see 'man fstab-sync' for details
#/dev/VolGroup00/LogVol00 /                       ext3    defaults        1
1
/dev/VolGroup00/LogVol00/domains/vm1disk /                       ext3   
defaults        1 1
LABEL=/boot             /boot                   ext3    defaults        1 2
/dev/devpts             /dev/pts                devpts  gid=5,mode=620  0 0
/dev/shm                /dev/shm                tmpfs   defaults        0 0
/dev/proc               /proc                   proc    defaults        0 0
/dev/sys                /sys                    sysfs   defaults        0 0
/dev/VolGroup00/LogVol01 swap                    swap    defaults        0 0
#/dev/fd0                /media/floppy           auto   
pamconsole,exec,noauto,managed 0 0
#/dev/hda                /media/cdrom            auto   
pamconsole,exec,noauto,managed 0 0


_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users