[Xen-users] Xen won't boot after connecting to EMC san

[John S Little <JSLittl@xxxxxxxxxxxxx>]

Hi all,

I've installed Xen 3 from Mercurial.  The Xen3 kernel boots ok finding all 
of the necessary devices until I plug in the fibre connection to the san. 
When I do that it fails just after finding sdc (the san drive) with the 
message:

can't find sda3 (this is the / partition)
/bin/sh: can't access tty; job control turned off

I'm using a SLES 9 sp 2 box.  My menu.lst is:

title Xen 3.0 / XenLinux 2.6
        kernel (hd0,0)/xen-3.0.gz console=vga dom0_mem=262144
        module (hd0,0)/vmlinuz-2.6-xen selinux=0 root=/dev/sda3 
console=tty0
        module (hd0,0)/initrd-xen

Any idea why adding the san drive (sdc) would cause it to not be able to 
find sda3 (the / drive)?

Thanks for any ideas, insights and suggestions.

John Little
Hendricks Regional Health IS Department
317-718-4752
jslittl@xxxxxxxxxxxxx
http://www.hendrickshospital.org

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users