[Xen-ia64-devel] RE: [Patch] Enable boot param pass on XEN/IA64

["Magenheimer, Dan (HP Labs Fort Collins)" <dan.magenheimer@xxxxxx>]

Patch applied to my local tree (until I get ski and
rx2600 serial working too).  I fixed one minor
problem... guest_cmd should probably skip leading
spaces after the "--" separator.

Dan 

> -----Original Message-----
> From: Tian, Kevin [mailto:kevin.tian@xxxxxxxxx] 
> Sent: Tuesday, May 31, 2005 9:32 PM
> To: Magenheimer, Dan (HP Labs Fort Collins)
> Cc: xen-ia64-devel@xxxxxxxxxxxxxxxxxxx; Keir Fraser
> Subject: [Patch] Enable boot param pass on XEN/IA64
> 
> Hi, Dan,
>       Attached is the patch to enable boot param parse on XEN/IA64.
> Previously the whole command line is only for guest, with xen to use
> some default hardcode config. With this patch, now user can use
> "com2=57600,8n1 console=com2" style to steer xen. This change also
> accommodate Keir's serial clean, to make serial re-work on 
> VTI on Tiger4
> box. Based on comment from list, now user should use "--" to split the
> command line, with the latter part for guest kernel. Example like:
> "com2=57600,8n1 console=com2 -- console=ttyS1 console=tty 
> root=/dev/sda3
> ro"
>       Patch is made upon xeno-unstable, which can be checked into
> xeno-unstable-ia64 after sync.
> 
> Signed-off-by Kevin Tian <Kevin.tian@xxxxxxxxx>
> 
> Thanks,
> Kevin
> 

_______________________________________________
Xen-ia64-devel mailing list
Xen-ia64-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-ia64-devel